What the RAM Drill-Down Mount for Trimble TDS Recon Includes

The RAM-101-B-TD1 mount is designed for the Trimble TDS Recon PDA. It uses the RAM 1.5-inch diameter ball and socket system, combining a composite cradle with a short arm. The back of the cradle connects to a round base with a ball, which allows the cradle to attach to the RAM arm. All cables can stay connected to the TDS Recon while it is in the cradle.

Product Facts for the RAM-101-B-TD1

  • RAM® Drill-Down Mount for Trimble TDS Recon: The RAM-101-B-TD1 consists of a 1.5-inch diameter ball and socket system with a composite cradle and short arm. This system provides a stable, adjustable mount that can be positioned in many viewing angles.

    RAM® Drill-Down Mount for Trimble TDS Recon

    RAM® Drill-Down Mount for Trimble TDS Recon

  • RAM® Drill-Down Mount for Trimble TDS Recon: The back of the cradle is connected to a round base with a ball, allowing connection to the RAM arm. The ball and socket joint enables you to move the cradle into various viewing locations.

  • RAM® Drill-Down Mount for Trimble TDS Recon: All cables can stay connected to the TDS Ranger while in the RAM cradle. You don't need to disconnect cables each time you mount or remove the device.

Installation Steps for the RAM Drill-Down Mount

Follow these steps to mount the RAM-101-B-TD1 on a flat surface. Ensure you have a suitable drill and the correct drill bit for your surface material.

  1. Prepare the mounting surface: Choose a clean, flat surface where you want the mount. Mark the drill points according to the base plate pattern. The mount uses a drill-down base, so you will need to drill holes for mounting screws.
  2. Attach the round base with ball: Secure the round base to the surface using the provided hardware (not supplied in this record; use appropriate bolts for your surface). Ensure the base is tight and level.
  3. Connect the short arm to the base: The short arm attaches to the ball on the base. The ball and socket joint allows you to adjust the angle before tightening.
  4. Mount the composite cradle: The cradle is designed specifically for the Trimble TDS Recon. Place the device into the cradle, ensuring cables remain connected. Secure the cradle to the arm.
  5. Adjust the viewing angle: Loosen the ball and socket joint to reposition the cradle. Tighten once you have the desired viewing angle.

Checkpoints Before You Drill

Before drilling, verify the mounting surface is solid and can support the weight of the mount and device. The supplied information does not include specific torque or drill bit sizes; use standard hardware for your surface type. Ensure the drill-down base is aligned so the cradle does not interfere with nearby equipment.