Quick answer
Mount the RAM Magnetic Double Ball Mount with LED Spotlight on a flat, clean steel surface within easy reach of the 12V socket, then adjust the double ball arm so the 30-degree spot beam hits your work area without glare. Check the magnet's grip and the cord routing every time you ride.
Why the magnetic base needs a flat steel surface
The magnetic base holds best on smooth, unpainted steel. Curved, textured, or aluminum surfaces reduce holding strength, so test the spot before you trust it with the light. If your mounting point is not steel, consider a different RAM base rather than forcing this one.
Aim the 30-degree spot before you tighten
The LED bulb projects a 30-degree spot, which is narrow enough to light a specific task but not a whole campsite. Set the angle while the light is on and you are in your normal riding or working position. The double ball arm lets you make small adjustments without tools, but tighten the knob firmly once you are happy.
Cord management and weather resistance
The long cord with standard 12V plug gives you flexibility, but a loose cord can snag on controls or catch wind. Route it along a frame tube or under a seat edge and leave a small service loop at the plug. The weather-resistant body shields the LED from rain and spray, but the plug connection itself should stay dry when not in use.
Six steps to place and care for your magnetic spotlight mount
- Choose a flat steel spot: Pick a clean, flat steel surface near where you need light. Avoid curved plastic, aluminum, or painted surfaces that may not hold the magnet securely. Test the magnet's grip by pulling gently before you mount the light.
- Clean the surface and magnet: Wipe the steel and the magnet base with a damp cloth to remove dust, oil, or grit. A clean contact patch gives the strongest hold. Re-clean the magnet after every off-road trip.
- Attach the base and check stability: Set the magnetic base down and press firmly. Try to slide it sideways; it should resist movement. If it shifts easily, find a flatter spot. A base that slides by hand will not stay put on rough terrain.
- Adjust the double ball arm: Loosen the knob, position the arm so the light points at your work area, and tighten firmly. Make small changes with the light on to check the beam. Tighten the knob by hand only; over-tightening can damage the ball joints.
- Route the 12V cord safely: Run the cord away from moving parts, hot surfaces, and controls. Leave a small loop at the plug so the connection is not pulled tight. Check the cord routing each time you mount the light.
- Do a pre-ride check: Before each use, confirm the magnet is secure, the arm is tight, and the plug is fully seated. Remove the light if you will be on very rough ground or at high speed. When in doubt, take the light off and stow it.
Product facts
-
RAM® Magnetic Double Ball Mount with LED Spotlight: The redesigned LED bulb is brighter and more efficient, lowering power draw. You get more light with less battery drain, which matters on smaller ATV or boat electrical systems.
RAM® Magnetic Double Ball Mount with LED Spotlight
-
RAM® Magnetic Double Ball Mount with LED Spotlight: The weather-resistant body shields the 30-degree spot LED from the elements. You can leave the mount in place in wet conditions, but you should still protect the 12V plug when it is disconnected.