What the 050009 CV Driveshafts Are
The Redcat 050009 is a pair of front and rear CV driveshafts made from steel. They are listed as a spare part for the RAMPAGE MT and also noted for the legacy RAMPAGE DUNERUNNER. If you own one of these vehicles and notice driveline issues, these driveshafts are a likely suspect.
Common Wear Signs on the 050009
Steel CV driveshafts can wear in a few predictable ways. Look for these signs before ordering a replacement:
Excessive play at the CV joint: If you can wiggle the shaft side-to-side at the joint more than a tiny amount, the internal bearings or the joint itself are worn. This causes vibration and can lead to a broken shaft.
Visible bending or cracks: Steel can bend under extreme loads. Check the entire shaft length for any kinks or hairline cracks, especially near the joint cups.
Loss of grease or dirt ingress: If the rubber boots are torn or missing, dirt gets into the joint and accelerates wear. A dry, gritty feel when rotating the shaft by hand is a clear problem.
Uneven wear on the splines: Where the shaft connects to the axle or differential, the splines can get rounded off if the retaining pin is loose or missing.
050009 Catalog Facts
-
050009: The 050009 is a pair of front/rear CV driveshafts made of steel, listed as a spare part for the RAMPAGE MT and the legacy RAMPAGE DUNERUNNER. Confirms the part is steel, not plastic, and is specific to these two RAMPAGE models. If you have a different vehicle, this part will not fit.
050009
-
050009: The catalog price is USD 27.46, compared to a catalog comparison price of USD 40.99. Gives a realistic cost expectation for a replacement pair. The discount from the comparison price may reflect typical retail pricing.
How to Diagnose 050009 Problems Before Ordering
Follow these steps to confirm the driveshafts are the issue and that a replacement is the right fix.
- 1. Check the part number on your existing shaft: Look for a stamped number or compare visually with known 050009 images. If your shaft is a different part number, the 050009 may not fit your vehicle.
- 2. Inspect both driveshafts: Remove the shaft from the vehicle and check for the wear signs listed above. If only one side is worn, consider replacing both for balanced performance.
- 3. Verify vehicle compatibility: The 050009 is confirmed for RAMPAGE MT and RAMPAGE DUNERUNNER. If you have a different RAMPAGE variant or another model, the catalog does not guarantee fitment.
- 4. Decide if replacement is needed: If the shaft shows any of the wear signs, replacement is the safest fix. Steel shafts can fail suddenly under load, causing further damage.
What the Catalog Does Not Tell You
The catalog confirms the 050009 is a steel CV driveshaft pair for the RAMPAGE MT and DUNERUNNER, but it does not include installation instructions, torque specs, or a list of required tools. It also does not specify the length of the shafts or the diameter of the CV joint. If you need these details, check your vehicle's manual or measure your existing shaft before ordering.
If your problem is not wear but a different symptom—like a clicking noise from the differential or a bent axle housing—the 050009 may not be the root cause. Diagnose the entire driveline before buying parts.
