Quick answer
Replace the paint nozzle seal nut only with the Revell 39101 spare, and tighten it just enough to stop leaks without crushing the nozzle. Clean the threads first, then fit the new nut by hand before adding any torque.
Why a seal nut leaks and when replacement is the right fix
Paint leaking from the nozzle area usually comes from a worn or damaged seal nut, not from the paint itself. If cleaning the threads and reseating the nozzle does not stop the leak, the seal is the likely culprit. Replacing it restores a clean, controlled spray pattern and prevents paint from creeping into the air passages.
Do not substitute a generic nut or seal. The Revell 39101 seal nut is made for the Spray Gun Standard Class, and a mismatched part can damage the nozzle threads or fail to seal at all.
What to check before you order the spare
Confirm your spray gun is the Revell Spray Gun Standard Class (item no. 39101). The seal nut is compatible only with that model, so check the item number on the gun body or manual before buying. If the number is missing or unreadable, treat the part as unverified and contact the seller rather than guessing.
Inspect the nozzle and needle for bent tips or deep scratches. A damaged nozzle will keep leaking even with a new seal nut, so address that first. Also check that the old nut's threads are not seized or cross-threaded, which can make removal difficult.
Step-by-step seal nut replacement
- Clean the nozzle area: Remove the old seal nut and flush the nozzle threads with a soft brush and suitable cleaner. Dry fully before fitting new parts. Checkpoint: any leftover paint or solvent on the threads can cause a false seal or corrosion.
- Inspect the nozzle and needle: Look for bends, burrs, or cracks on the nozzle tip and needle. If damaged, replace them before installing the new seal nut. Checkpoint: a damaged nozzle will leak even with a new seal nut.
- Hand-thread the new seal nut: Thread the Revell 39101 seal nut on by hand until it seats. Do not use tools at this stage. Checkpoint: if it binds, stop and re-clean the threads; forcing it causes cross-threading.
- Tighten gently: Snug the nut with a suitable wrench only until it stops leaking during a test spray. Avoid over-tightening. Checkpoint: over-tightening can crush the seal or crack the nozzle.
- Test with plain water: Fill the cup with water and spray onto scrap card. Check for drips at the nozzle and adjust tightening if needed. Checkpoint: a fine mist with no drips means the seal is seated correctly.
Spare part details
-
Paint Nozzle Seal Nut (39101): Revell Paint Nozzle Seal Nut (39101) is a replacement component for the Spray Gun Standard Class (item no. 39101). Using the correct part ensures a proper seal and avoids damage to the nozzle threads.
Paint Nozzle Seal Nut (39101)
