Why You May Need Replacement Screws for Your EZ or PE Transmitter

Over time, the small screws that hold your EZ or PE series transmitter together can loosen, strip, or simply get lost during battery changes or repairs. Without the correct screws, the transmitter case may not close securely, which can affect the device's water resistance and overall reliability. This guide explains what you need to know about the replacement screw set designed specifically for these transmitters.

What the Catalog Confirms About the Screw Set

  • SCREWS FOR EZ/PE SERIES TRANSMITTERS ( SET OF 7 ): The product is called 'SCREWS FOR EZ/PE SERIES TRANSMITTERS ( SET OF 7 )' and costs $0.28 (catalog comparison price $0.55). This confirms the set includes seven screws, which matches the typical number needed for an EZ or PE series transmitter. The low price makes it an affordable fix.

    SCREWS FOR EZ/PE SERIES TRANSMITTERS ( SET OF 7 )

    SCREWS FOR EZ/PE SERIES TRANSMITTERS ( SET OF 7 )

How to Replace the Screws on Your EZ/PE Transmitter

Replacing the screws is a straightforward task that requires minimal tools. Follow these general steps; always refer to your transmitter's manual for device-specific instructions.

  1. Remove the old screws: Using a small Phillips or flathead screwdriver (depending on your transmitter model), carefully unscrew and remove all seven screws from the transmitter case. Keep them in a safe place in case you need to match sizes.
  2. Check the screw holes: Inspect each screw hole for debris or stripped threads. If a hole is damaged, the new screw may not seat properly. Use a toothpick or compressed air to clear any dust.
  3. Install the new screws: Insert each new screw from the set into its corresponding hole. Tighten gently until snug—do not overtighten, as this can strip the threads or crack the plastic housing.
  4. Test the closure: After all screws are in place, close the transmitter case and ensure it seals evenly. If any screw feels loose or the case gapes, double-check that you are using the correct screw for that position.

Compatibility at a Glance

This screw set is specifically listed for EZ and PE series transmitters. It is not confirmed to fit other transmitter series (such as the 900 series or large round transmitters). If you own a different model, check the product description or contact support before purchasing. Using the wrong screw size could damage the threads or fail to secure the case.

Honest Tradeoffs to Consider

The set of seven screws costs only $0.28, making it an inexpensive repair option. However, the catalog does not specify the exact thread size or length, so you cannot verify compatibility with third-party transmitters or non-EZ/PE models. Additionally, the set includes only screws—no washers or gaskets—so if your transmitter's water seal is compromised, you may need a separate gasket replacement.