Start with what the SP20 Cuff LTH WP+ is built from

The SP20 Cuff LTH WP+ pairs a leather and suede upper with a bootie construction and a waterproof membrane rated WP+. That combination is what keeps your feet dry on rain-soaked commutes, but it also means you need to treat the outside as two different materials: smooth leather and suede. Cleaning one like the other is the fastest way to dull the finish or mat the nap.

Before you touch a brush, check the care label inside your boots. The product record confirms the upper is 60% leather, 30% suede and 10% synthetic, with a 100% polyester lining and a TPR outsole. It does not list a specific cleaner, brush type or waterproofing spray, so choose products labeled safe for mixed leather and suede and always test on a small hidden area first.

The materials that shape your cleaning routine

  • 79568-614-M | SP20 CUFF LTH WP+: Upper: 60% leather, 30% suede, 10% synthetic. Lining: 100% polyester. Insock: 85% foam, 15% polyester. Outsole: 100% TPR. Heel height: 25mm. Leather and suede need different care, so a single all-purpose cleaner can be too harsh for one of them. The synthetic content and polyester lining also dry differently from leather, which affects how long you air-dry.

    79568-614-M | SP20 CUFF LTH WP+

    79568-614-M | SP20 CUFF LTH WP+

A safe cleaning routine for mixed leather and suede

Work in this order to lift dirt without pushing it deeper into the suede or scratching the leather.

  1. 1. Brush off loose dirt while the boots are dry: Use a soft brush or a dry cloth to remove surface dust and grit. Pay attention to the welt and the area around the lace eyelets, where road salt and mud collect. Do not scrub wet dirt into the suede.
  2. 2. Wipe the leather panels with a damp cloth: Dampen a microfiber cloth with water and wring it out well. Wipe only the smooth leather sections, then dry immediately with a clean towel. Avoid soaking the seams or the suede.
  3. 3. Clean suede with a dedicated suede brush or eraser: Once the suede is dry, gently brush in one direction to restore the nap. For scuffs, use a suede eraser with light pressure. Do not use water or leather cleaner on suede unless the product specifically says it is safe for suede.
  4. 4. Air-dry away from direct heat: Stuff the boots with newspaper or a dry cloth to hold their shape and absorb moisture. Leave them in a well-ventilated spot, away from radiators, fires or direct sun. Heat can crack leather and shrink the synthetic lining.

What the WP+ rating does and does not promise

The SP20 Cuff LTH WP+ is listed with a WP+ waterproof level and a bootie construction with a waterproof membrane. That is good news for rain-soaked city streets and cold morning commutes, but it is not a claim of unlimited waterproofing. The membrane is inside the boot, and the leather and suede upper still needs basic care to keep its finish intact.

The supplied product record does not include a care or waterproofing instruction, so do not assume you need to re-proof the membrane. If you choose to use a waterproofing spray on the exterior, pick one labeled safe for leather and suede and follow its directions. Never apply spray to a wet boot, and always test on a hidden area first.

Everyday habits that protect the leather, suede and membrane

  • Rotate your boots: Give the SP20 Cuff LTH WP+ a full day to dry between wears. Moisture trapped inside the bootie construction weakens the lining and can lead to odors.
  • Loosen the laces before pulling them on: The boot has a lace closure with a top d-ring and eyelets. Undoing the laces reduces stress on the eyelets and the leather around them, which keeps the fit consistent.
  • Use the heel webbing loop: Pull the boots on by the heel loop rather than by the suede collar. This prevents stretching and keeps the suede details looking sharp.
  • Store them clean and dry: Brush off dirt before storing. Keep the boots in a cool, dry place, not a damp closet or a sealed plastic bag, so any remaining moisture can escape.

Sizing and fit notes that affect how you wear them

The catalog lists the SP20 Cuff LTH WP+ fitting as normal, and the available sizes run from Womens 7.5 / Big Kids 6 up to Mens 11.5 / Womens 13. That overlap means you can often find a precise fit across men's, women's and big kids' sizing, but it does not tell you how the boot feels with thick winter socks. If you plan to wear heavyweight socks, consider whether your usual size leaves enough room; the record does not confirm how much extra space to allow.

A proper fit also helps the boot last. If the boot is too tight, the leather and suede flex more than intended; too loose and you may scuff the toe or roll the ankle. Use the lace closure to adjust the instep, and remember the heel height is 25mm, which is a modest lift for a boot of this style.

Fit and construction details worth knowing

  • 79568-614-M | SP20 CUFF LTH WP+: Fitting: normal. Closure: lace with round laces, top d-ring and eyelets, heel webbing loop. Construction: bootie construction with waterproof membrane. A normal fit and lace closure give you room to adjust, but the bootie construction means the membrane is built in, so you do not need to treat the inside. The heel loop helps you put the boots on without crushing the suede collar.

When to stop cleaning and seek professional help

If you see a tear in the leather, a deep stain on the suede that does not lift with a suede eraser, or a separation at the sole, stop cleaning. The supplied record does not include repair instructions, and home remedies can make damage worse. A local cobbler or leather specialist can assess whether the boot can be repaired.

For light maintenance, stick to the routine above. The SP20 Cuff LTH WP+ is designed for winter city wear, and with regular brushing and proper drying, the leather and suede will keep their sporty, elegant look through the season.