Quick answer
Use the STURDY Back to Back Handle Fitting kit to mount matching handles on both sides of a cupboard door. It supplies the disks and fixings needed for a clean through-door installation.
Why through-door mounting needs the right fitting
A double sided cabinet handle is more than two handles screwed in place. The door thickness and handle design determine whether the two sides align cleanly. The STURDY kit is designed for back-to-back installation on internal swing or sliding doors, so it takes the guesswork out of pairing handles.
Antique brass and the finish trade-off
The antique brass finish on the STURDY fitting has a clear matte coating that slows the natural aging process. Brass will still change over time, especially in humid rooms. If you want a perfectly uniform look across both sides, keep in mind that the two handles may age slightly differently depending on light and handling.
Step-by-step fitting
- Check door thickness and handle compatibility: Measure the door thickness and confirm that your chosen handles and the STURDY kit suit it. The kit is made for back-to-back mounting on internal swing or sliding doors. If the door is hollow or unusually thin, test the fixing before drilling.
- Mark both sides precisely: Use the handle as a template to mark the fixing holes on one side, then transfer the marks to the opposite side with a square or by drilling a pilot through. A common mistake is marking each side independently, which causes misalignment. Clamp a scrap block behind the door to prevent tear-out when the drill exits.
- Drill through the door: Drill a pilot hole from one side, then drill from the opposite side to meet in the middle. This avoids splintering around the exit hole. Keep the drill perpendicular; a slight angle will make the handles sit crooked.
- Fit the first handle with the STURDY disk: Place the STURDY disk against the door face and pass the fixing through the handle and door. Tighten gently so the disk sits flush without crushing the door surface. Do not overtighten; the clear matte coating on the brass can be damaged by excessive force.
- Attach the second handle back-to-back: On the opposite side, align the second handle and disk with the fixing and tighten. Check that both handles are level and operate smoothly. Open and close the door a few times to confirm the handles do not rub or catch.
- Final check and care: Wipe fingerprints with a soft dry cloth. Avoid abrasive cleaners that could dull the matte coating. Recheck the fixings after a week of use, as slight settling can occur.
Product facts
-
STURDY Back to Back Handle Fitting - Antique Brass: Solid brass with a clear matte coating; disk diameter 22mm and thickness 5.4mm. The solid brass build and coating help the fitting resist wear, while the slim disk profile keeps the installation neat on the door face.
STURDY Back to Back Handle Fitting - Antique Brass
