Start with the model, not the battery

Before you open anything, confirm that your unit is a Velux Integra Solar or a KSX 100K. The CELLONIC 865103 replacement is listed specifically for those models, and the 2000 mAh capacity is the headline number you will see on the label. If your unit carries a different model number, stop here: the supplied information does not confirm fit for anything else, and guessing is how people end up with a battery that does not seat or power the unit correctly.

This guide covers what the supplied product record actually supports: the model match, the capacity, and the fact that the battery is a standard-size replacement designed to sit in an existing compartment. It does not include a manufacturer service procedure, torque values, or reset steps, because those details are not part of the supplied evidence. Treat the steps below as a careful, general replacement routine, and consult your Velux documentation for any model-specific instructions.

What the 865103 replacement specifies

Replacement walkthrough

These steps follow the physical logic of a standard compartment battery swap. They are not a Velux service manual, and the supplied record does not include model-specific opening instructions, so use your unit's own documentation where it differs.

  1. 1. Match the model and part number: Check the label on your Integra Solar or KSX 100K unit and confirm the 865103 designation before ordering. The supplied record lists those two model families only.
  2. 2. Power the unit down: Switch off or isolate the unit according to its own instructions before opening the battery compartment. The supplied record does not specify a shutdown sequence, so follow Velux guidance here.
  3. 3. Open the battery compartment: Access the existing compartment as your unit's documentation describes. The replacement is a standard-size battery intended for that compartment, so no modification should be needed.
  4. 4. Note the orientation, then remove the old battery: Photograph or sketch the old battery's position before lifting it out. The supplied record does not state polarity markings or connector details, so your own photo is the safest reference for refitting.
  5. 5. Seat the 2000 mAh replacement: Place the CELLONIC 865103 battery in the same orientation as the old one and confirm it sits flush. The standard-size design is meant to drop into the existing compartment.
  6. 6. Close up and test: Reassemble the compartment, restore power, and operate the unit through a normal cycle. If it does not respond, recheck orientation and seating before assuming the battery is faulty.

Where the supplied information stops

The record gives you capacity, model compatibility, standard sizing, and general durability language. It does not give charging times, expected years of service, storage voltage, disposal instructions, or a step-by-step Velux procedure. That is a limit of the supplied evidence, not a statement that those details do not exist elsewhere. If you need them, the Velux documentation for your specific unit is the right source.

It also does not confirm interoperability with any other Velux model, remote, or accessory. The 865103 replacement is listed for Integra Solar and KSX 100K units, and that is the boundary to work within.

Original pack vs the CELLONIC 865103

The supplied record does not include original Velux specifications, so this comparison stays at the level the evidence supports.

  • Model coverage: The CELLONIC replacement is listed for Velux Integra Solar and KSX 100K. Original pack coverage is not stated in the supplied record.
  • Capacity: 2000 mAh is the stated capacity of the replacement. No original capacity figure is supplied, so no direct capacity comparison can be made.
  • Physical fit: Described as standard size for existing compartments. Whether an original pack differs in dimensions is not confirmed.
  • Price: Catalog price is USD 21.51 against a comparison price of USD 34.15. That is a catalog figure, not a claim about long-term value.

Checks before you order

  • Your unit's model label: Confirm Integra Solar or KSX 100K. If the label says something else, the supplied evidence does not support this replacement.
  • The old battery's markings: Compare the part number on the battery you are removing with 865103. A mismatch is a reason to pause, not to force the fit.
  • Compartment condition: Look for corrosion or swelling before fitting a new battery. The supplied record gives no cleaning or remediation steps, so address damage before installation.
  • What you actually need from the swap: If the unit is unresponsive for reasons unrelated to the battery, a replacement may not solve it. The supplied record does not include diagnostic steps.