Quick answer

Build the Washhouse 28mm kit by dry-fitting every MDF part first, then gluing in stages—walls, roof, and details—before painting and sealing. Work on a clean, flat surface and keep the instructions handy for part numbers.

Why dry-fitting matters with laser-cut MDF

Laser-cut MDF parts can vary slightly due to kerf and humidity, so a dry run reveals tight joints before glue locks them. It also lets you plan sub-assemblies—like the removable roof—so you don’t trap yourself mid-build.

The washhouse includes etched detailing and a removable roof, which means you should test how the roof sits before committing to glue. A dry fit now saves rework later.

Preparing and painting MDF before assembly

Painting flat parts before assembly is easier, but glue doesn’t stick well to painted edges. Mask joint surfaces with tape or scrape paint away before gluing. A primer designed for MDF helps paint adhere and reduces swelling from water-based paints.

If you prefer to paint after assembly, be ready to reach inside corners with a brush. Either way, seal the MDF edges to prevent moisture damage over time.

Step-by-step assembly

  1. Lay out and identify all parts: Unpack the kit and match each MDF sheet to the parts list in the instructions. Group parts by sub-assembly (walls, roof, details) and keep them on a tray. Missing or damaged parts are easiest to spot before assembly—check now.
  2. Dry-fit the main walls and floor: Slot the walls and floor together without glue. Check for square by measuring diagonals; adjust if needed. Don’t force tight joints—if a tab won’t seat, lightly sand the edge. A square base prevents a twisted building later.
  3. Glue the wall sub-assembly: Apply a thin bead of PVA or wood glue to joints and press parts together. Use a square to confirm corners and wipe away excess glue immediately with a damp cloth. Excess glue blocks paint adhesion—clean as you go.
  4. Test-fit and set aside the removable roof: Assemble the roof panels without glue first, then glue only the roof structure itself—not to the walls. Check that the roof lifts off easily and sits flush. If the roof binds, sand the contact points lightly before painting.
  5. Attach etched details and fittings: Glue any interior or exterior detail parts (like bath/shower units) after the main structure is dry. Use tweezers for small pieces and avoid over-gluing. Let the main build cure fully before adding fragile details.
  6. Paint and seal: Prime with an MDF-compatible primer, then paint with acrylics. Seal with a matte varnish, especially on edges and the roof, to protect against handling. Test your paint on a spare MDF offcut first to check adhesion.

Kit facts at a glance

  • Washhouse (28mm): Supplied unassembled and unpainted in kit form with full instructions. You’ll need glue, paint, and basic tools—nothing is pre-finished, so plan your finish before you start.

    Washhouse (28mm)

    Washhouse (28mm)

  • Washhouse (28mm): Includes etched detailing and a removable roof. The etched surfaces reward careful painting, and the removable roof makes interior access easier during assembly and painting.