Quick answer
Take your waterproof Magic Wand into the shower only after you have a dry place to set it down, a firm grip, and a plan to rinse and dry it completely afterward. Keep the charging port and any seams away from direct spray, and never leave the wand sitting in water.
Why the shower changes the routine
Water makes tile and skin slippery, and it also carries soap and shampoo into places you may not expect. That means the main risks with a wand vibrator in the shower are drops and residue, not the vibration itself. Set up before you turn the water on so you are not juggling a wet wand and a bottle at the same time.
Heat is the other difference. A long, hot shower can make you lightheaded, so keep sessions shorter than you would in bed and step out if you feel dizzy. If your bathroom has no dry shelf or hook within reach, treat the shower as a poor fit and use the wand elsewhere.
Where a waterproof wand still needs caution
Waterproof does not mean you should submerge the wand or point the showerhead directly at the charging port or control buttons. Rinse and dry those areas by hand instead. If the wand has a removable silicone cover or attachment, check that it is seated firmly before you get it wet.
Skip bath oils and gritty scrubs around the wand. They can leave a film that is hard to rinse off and can make the surface slippery. Mild soap and warm water are enough for cleaning after use.
Shower-ready steps for your waterproof Magic Wand
- Set up a dry base first: Place a dry towel or a small shelf within arm's reach and put the wand there before you turn on the water. Common mistake: setting the wand on a wet ledge or the shower floor, where it can slide or sit in water. If there is no dry spot within reach, use the wand outside the shower instead.
- Check the seals and attachments: Confirm that any silicone cover or attachment is pushed fully into place and that the charging port cover is closed. Common mistake: assuming the wand is sealed without checking, especially after changing attachments. A loose cover or attachment is a reason to stop and reseat it before the wand gets wet.
- Keep the spray off the controls: Angle the showerhead away from the wand and use your body to shield the buttons and charging port. Common mistake: holding the wand directly under the stream to rinse it. Rinse the wand by hand with a trickle of water, not a direct spray.
- Start on the lowest setting: Turn the wand on before it gets wet and begin at the lowest power level, then adjust upward. Common mistake: fumbling with buttons on a slippery wand in the middle of a shower. Set the pattern and power before you add water, so you are not pressing buttons with wet hands.
- Keep a firm grip and shorten the session: Hold the wand by its handle, keep your other hand free for balance, and plan to finish within a few minutes. Common mistake: staying in hot water so long that you feel lightheaded. Step out and sit down if you feel dizzy, and leave the wand on its dry base.
- Rinse, wash, and dry completely: After the shower, wipe the wand with a mild soapy cloth, rinse the surface by hand, and dry every seam and the charging port with a towel. Common mistake: putting a damp wand straight into a drawer or case. Leave the wand out to air-dry fully before storing or charging it.
Product facts
-
The Waterproof Magic Wand - Your Favorite Vibrator, Now Waterproof!: The Waterproof Magic Wand is rechargeable, has more power levels and vibration patterns than the original, and is compatible with the same Hitachi wand attachments. You can use the wand in the shower without a cord, and your existing wand attachments still fit, so you do not need a separate set for water play.
The Waterproof Magic Wand - Your Favorite Vibrator, Now Waterproof!