What These Decals Are Made For

The Bandai Waterslide Decals for High Grade (HG) Macross Delta 1/100 VF-31S Siegfried (Arad Molder Use) are designed specifically for that kit. If you are building the 1/100-scale HG VF-31S Siegfried as piloted by Arad Molder, these decals add markings that printed stickers cannot match. They let you place each marking exactly where you want it, with no thick carrier film showing.

Key Facts About This Decal Set

Application Steps for Clean Results

Waterslide decals require a few more steps than stickers, but the result is worth it. Follow these steps for a smooth application.

  1. Prepare the surface: Make sure the plastic is clean and free of dust or oil. A gloss clear coat before decaling helps the decal slide into position and reduces silvering (trapped air under the film).
  2. Cut out the decal: Use a sharp hobby knife or scissors to cut close to the printed area. This reduces excess clear film around the marking.
  3. Soak in warm water: Dip the decal in room-temperature or slightly warm water until the decal loosens from the backing paper. Follow the supplied product instructions for the exact timing. Slide it onto the model using a damp brush or tweezers.
  4. Position and set: Gently slide the decal into place. Use a moist cotton swab to roll out any air bubbles and excess water. Let it dry completely.
  5. Seal the decal: Apply a clear topcoat (matte, satin, or gloss) over the decaled area. This protects the marking and blends it into the surrounding paint.

What the Supplied Information Does Not Cover

The catalog confirms these decals are made for the 1/100-scale HG VF-31S Siegfried (Arad Molder use), but it does not include application instructions, recommended setting solutions, or care intervals. For best results, use standard waterslide techniques and test on a spare part if you are new to decaling.