Quick answer
To keep your XS7 Auto Stroker performing at its best, disassemble the sleeve and removable parts after each use, rinse with lukewarm water and a mild toy cleaner, air-dry completely, and store in a dust-free case.
Why regular maintenance matters
The XS7 Auto Stroker uses advanced Gen 2 Contraction Technology and AirPulse Rhythm to create realistic sensations. Built-up residue can clog the internal air channels or damage the silicone sleeve, reducing suction and clamping performance over time. A quick clean after every session preserves both hygiene and the device's unique motion patterns.
What to avoid
Never submerge the motorized base or control unit in water—only the sleeve and removable silicone parts are waterproof. Avoid alcohol-based wipes or harsh detergents, which can degrade the sleeve material. Skip the dishwasher and boiling water; high heat can warp the internal mechanisms.
Step-by-step cleaning process
- Disassemble the stroker: Remove the silicone sleeve from the motorized base. Pull off any detachable rings or caps. Check the user manual for your specific model—some sleeves are reversible and need to be turned inside out for thorough rinsing. Common mistake: Forgetting to remove the sleeve can trap moisture inside the motor housing.
- Rinse with lukewarm water: Hold the sleeve under lukewarm running water (not hot) for 20–30 seconds. Apply a small amount of mild toy cleaner or unscented antibacterial soap to your fingers and work it over the entire surface, including the internal texture. Rinse again until no suds remain. Checkpoint: Avoid soap with moisturizers or fragrances—they leave a film that attracts dust.
- Dry thoroughly before reassembly: Pat the sleeve with a lint-free microfiber cloth. Let it air-dry on a clean towel for at least 1–2 hours, turning it inside out if possible. Do not use a hair dryer or place it in direct sunlight—heat can damage the silicone. Common mistake: Reassembling while damp leads to mold growth and motor corrosion.
- Clean the motorized base: Wipe the base with a slightly damp cloth—never submerge it. Use a cotton swab dipped in rubbing alcohol to clean the charging port and control buttons. Let it air-dry for 10 minutes before storing. Checkpoint: Alcohol evaporates quickly and disinfects without soaking the electronics.
- Store properly: Place the clean, dry sleeve back into the motorized base. Store the stroker in a dust-free pouch or its original box. Keep it away from extreme temperatures and direct sunlight. Common mistake: Storing in a plastic bag traps moisture—use a breathable fabric pouch instead.
About your XS7 Auto Stroker
-
XS7 Auto Stroker with Gen 2 Contraction Tech Clamping Sucking Vibrating: Gen 2 Contraction Technology provides rhythmic clamping motions that simulate natural vaginal contractions. Keeping the sleeve and air channels free of debris ensures the clamping and suction mechanisms work smoothly, maintaining that realistic feel.
XS7 Auto Stroker with Gen 2 Contraction Tech Clamping Sucking Vibrating