Quick answer
Install the lock, pair it with the Yale Home app via Bluetooth, then set up entry codes and enable Auto-Lock with DoorSense for hands-free security.
Before you begin: Check your door prep and tools
The Yale Assure Lock 2 Touchscreen replaces most standard single-cylinder deadbolts. You'll need a Phillips screwdriver and a tape measure. If your door has a non-standard bore hole (diameter larger than 2-1/8 inches) or backset (distance from edge to center of hole) other than 2-3/8 or 2-3/4 inches, you may need an additional adapter plate or a different lock model. Verify your door dimensions against the template included in the box before removing your old lock.
Bluetooth range and app requirements
The Bluetooth module inside the lock communicates with your phone within about 30 feet, depending on walls and interference. For full remote access, you would need the Wi-Fi module (sold separately). The Yale Home app is required for initial setup and everyday management. It is available for iOS and Android, and you will need to create a free account.
Setup steps
- Remove the old lock and install the new deadbolt: Use the included template to mark and drill new holes if needed. Insert the deadbolt into the edge bore, aligning the faceplate with the door edge. Secure with the provided screws. Common mistake: Installing the deadbolt upside down — the angled side of the bolt should face the door frame striker plate. Test the deadbolt action with a screwdriver before attaching the exterior keypad.
- Mount the exterior keypad and interior escutcheon: Feed the cable from the exterior keypad through the door bore. Place the mounting plate on the interior side and attach the exterior keypad with the provided screws. Then connect the cable to the interior escutcheon and snap it onto the mounting plate. Common mistake: Pinching the cable between the escutcheon and the door — ensure the cable lies flat in its channel. Tighten screws just enough to hold; overtightening can warp the escutcheon.
- Insert batteries and pair via the Yale Home app: Install four AA batteries into the interior compartment. Open the Yale Home app, create an account or log in, and tap 'Add Device'. Follow the in-app prompts to scan for the lock. When the lock beeps and the keypad lights up, press the pairing button on the interior escutcheon (hold for 3 seconds). Common mistake: Forgetting to enable Bluetooth on your phone or standing too far from the lock during pairing — stay within 10 feet. If the app does not find the lock, remove and reinsert the batteries to restart the Bluetooth module.
- Create your entry codes and enable Auto-Lock: In the app, go to 'Manage Codes' and add a permanent code for yourself (4-8 digits). For guest codes, set an expiration date. Then enable Auto-Lock and set a delay (30 seconds by default). If your lock came with the DoorSense sensor, install it on the door frame and pair it in the app so the lock knows when the door is closed. Common mistake: Setting the Auto-Lock delay too short can cause the lock to engage while you are still walking through the door. Test Auto-Lock with the door open first to confirm the delay feels natural.
- Test all unlock methods and share access: Unlock using your touchscreen code, the app, and the physical key (if included). Confirm the lock beeps and the keypad lights flash green for success, red for failure. Then use the app to share a temporary or permanent code with a family member or guest. Common mistake: Not testing the physical key — if the lock's electronics fail, the key is your backup. Store a backup key outside your home (e.g., in a locked box) in case you are locked out without your phone.
Product facts
-
Yale Assure Lock 2 Touchscreen with Bluetooth: The Yale Assure Lock 2 Touchscreen with Bluetooth supports multiple ways to unlock, share and track entry codes, and Auto-Lock with DoorSense. You can give temporary codes to guests or service providers and see exactly who entered and when, all from the app.
Yale Assure Lock 2 Touchscreen with Bluetooth