Quick Answer

Attach the AMAP III Assault Pack to your plate carrier using the included straps and MOLLE/PALS webbing, then adjust compression and routing for your mission load. The pack converts from a low-profile 4-liter assault configuration to a larger carry capacity for longer operations.

Why the AMAP III Works with Plate Carriers

The AMAP III is designed as an assault/EDC crossover pack, meaning it can sit tight against your plate carrier for short raids or expand for extended patrols. Its universal mounting system attaches to the rear of most plate carriers without interfering with shoulder straps or cummerbund adjustments.

A common trade-off: the more you load the pack, the more it pulls rearward. Proper compression and strap routing keep the weight close to your body and prevent the pack from sagging during movement.

AMAP III Mounting Steps for Plate Carriers

  1. 1. Route the Top Straps: Thread the two top attachment straps over the top edge of your plate carrier's rear plate bag, then back through the buckles. Tighten so the pack sits flush against the carrier's back panel. Common mistake: leaving slack here causes the pack to droop and shift side-to-side.
  2. 2. Secure the Side MOLLE Tabs: Weave the side MOLLE tabs into the rear webbing of your plate carrier, starting from the top and working down. Use the outermost column of PALS slots for a stable connection. Checkpoint: ensure each tab is fully seated and not twisted; a half-weave can pull loose under load.
  3. 3. Adjust the Compression Straps: Pull the compression straps on each side of the pack to cinch the load tight against the carrier. For low-profile use, compress fully. For larger loads, loosen slightly but maintain tension. Common mistake: over-compressing a full pack can distort the internal shape and make gear hard to access.
  4. 4. Route the Sternum or Waist Strap (Optional): If your plate carrier has a front buckle or waist strap, route the AMAP III's lower stabilizer strap under the cummerbund and clip it to the front. This prevents rearward sag during dynamic movement. Skip this step for short-duration raids where quick doffing is a priority.
  5. 5. Test Full Range of Motion: Perform shoulder presses, torso twists, and a prone position check. The pack should not limit your rifle shouldering or force your head forward. Re-tension straps if needed. If the pack shifts more than an inch during movement, one of the top or side attachments is too loose.

Product Details

  • AMAP III™ Assault Pack: The AMAP III is an Assault/EDC Crossover pack that goes from super low-profile for short raids (4 Liters) to carrying considerable loads for longer missions. You can use one pack for both fast room-clearing drills and multi-hour patrols without swapping gear.

    AMAP III™ Assault Pack

    AMAP III™ Assault Pack