Quick Answer

Build the HG Nobell Berserker Gundam by following a clean assembly order, careful nub removal, and optional panel lining or topcoat for a sharper finish.

Why Build Order Matters

Assembling limbs before the torso can make posing harder later. Start with the core body to establish a stable base, then attach arms and legs. This order also helps you spot fit issues early without disassembling previous sections.

Nub Removal Tips for a Clean Look

The HG Nobell Berserker Gundam uses standard gate connections. Use a sharp side cutter to snip parts away from the runner, leaving a small nub. Then trim flush with a hobby knife and sand with fine-grit paper or a glass file. Avoid cutting too close initially to prevent stress marks on the plastic.

Step-by-Step Assembly Guide

  1. Prepare Your Workspace and Tools: Lay out all runners, a side cutter, hobby knife, sanding sticks or glass file, and tweezers for small decals. Check the manual for part numbers before cutting. Organize parts by runner letter to avoid mixing similar-looking pieces.
  2. Build the Torso and Head First: Assemble the chest, waist, and head unit. Ensure the polycaps (joints) are fully seated before moving on. The Berserker mode chest armor has two halves that snap together snugly—apply even pressure to avoid gaps. Test the head rotation before attaching the collar armor; it is easier to adjust now.
  3. Assemble the Arms and Shoulders: Snap together each arm segment, including the shoulder armor. The shoulder joints may feel tight—rotate them gently to loosen without forcing. Attach arms to the torso by aligning the peg and pressing evenly. If an arm feels loose, apply a thin layer of clear nail polish on the peg and let it dry before reattaching.
  4. Build and Attach the Legs: Construct each leg from hip to foot. The thigh armor on the HG Nobell Berserker Gundam has a sliding gimmick—ensure the inner tab slides freely before locking the outer shell. Attach legs to the waist ball joints. Check that the feet sit flat on a surface; adjust the ankle joint if the kit wobbles.
  5. Apply Panel Lining (Optional): Use a fine-tip Gundam marker or enamel wash to fill engraved panel lines. Wipe excess with a cotton swab lightly dampened with thinner or isopropyl alcohol. Focus on the Berserker mode armor grooves for maximum contrast. Let the liner dry completely (about 10 minutes) before handling to avoid smudges.
  6. Topcoat for Protection (Optional): Spray a thin, even coat of matte or gloss topcoat from 20–30 cm away in a well-ventilated area. Two light coats are better than one heavy coat to prevent pooling on the unique armor details. Mask the clear parts (if any) with painter’s tape to keep them transparent.

Kit Details

  • Nobell Berserker Gundam HG: This Nobell Berserker Gundam HG kit features the aggressive Berserker mode design with unique armor details and offers a straightforward assembly experience with classic High Grade quality. The unique armor panels require careful alignment, so following assembly order helps avoid forcing parts together and damaging the distinctive details.

    Nobell Berserker Gundam HG

    Nobell Berserker Gundam HG