Start with the simplest check: the bulb
Before you touch any wiring, confirm the bulb is the problem. A loose bulb, a failed filament, or a bulb that doesn't match the fixture's requirements can all keep a sconce dark. Turn off the wall switch, let the bulb cool, and reseat it firmly. If it still doesn't light, swap in a bulb you know works. If the new bulb lights up, you've found the issue—replace the old bulb with one that meets the fixture's specifications.
The Centric Petite Mesh uses a spun metal mesh shade, so you'll need to remove or open the shade to access the bulb. The supplied product record doesn't include bulb type, wattage, or shade removal instructions, so check the fixture's label or manual before you proceed. If you don't have that information, contact Blueprint Lighting for the correct bulb specification rather than guessing.
Check the wall switch and dimmer
If the bulb is good, the next suspect is the switch or dimmer. Test the sconce with a different wall switch if possible, or bypass the dimmer temporarily to see if the light comes on. A dimmer that isn't compatible with your bulb type—especially LED—can cause flickering, buzzing, or no light at all. This is a common mesh sconce dimmer issue, but the Centric Petite Mesh record doesn't specify dimmer compatibility, so verify with the manufacturer before assuming the dimmer is at fault.
Also check that the dimmer is turned up. It sounds obvious, but a dimmer left at its lowest setting can make a sconce appear dead.
What the Centric Petite Mesh record confirms
-
Centric Petite Mesh: The Centric Petite Mesh is a wall sconce with a spun metal mesh shade, a compact version of the Centric fixture. Knowing the shade is metal mesh helps you plan safe access to the bulb—turn off power and let the fixture cool before touching the shade.
Centric Petite Mesh
-
Centric Petite Mesh: The design pays homage to midcentury lighting and Mathieu Matégot's Rigitulle (perforated metal). The mesh shade is a design feature, not a removable component you should force. If it doesn't come off easily, stop and consult the manual.
Inspect the wiring connections
If the bulb and switch check out, the problem may be in the wiring. Turn off the circuit breaker before removing the fixture from the wall. Look for loose wire nuts, disconnected leads, or damaged insulation. Re-tighten any loose connections and cap any exposed wires. If you're not comfortable working with electrical wiring, stop here and call a licensed electrician—this is not a DIY step for everyone.
The Centric Petite Mesh record doesn't include wiring diagrams or installation instructions, so use the instructions that came with your fixture. If you've lost them, request a copy from Blueprint Lighting before you start.
Look for a tripped breaker or GFCI
A sconce that suddenly goes dark may be on a circuit that tripped. Check your electrical panel for a tripped breaker and reset it. If the sconce is in a bathroom, kitchen, or outdoors, it may be protected by a GFCI outlet—press the reset button on the GFCI. If the breaker trips again immediately, stop resetting it and call an electrician; there's likely a short circuit or ground fault that needs professional attention.
When to call an electrician
If you've checked the bulb, switch, dimmer, wiring, and breaker and the Centric Petite Mesh still won't light, the issue may be internal to the fixture or the circuit. At that point, professional help is the safe choice. An electrician can test voltage at the fixture, check for continuity, and diagnose problems that aren't visible. Don't keep swapping parts or opening the fixture repeatedly—that increases the risk of damage or injury.



