Quick Answer
To make your own dildo with a Clone A Willy kit, mix the molding powder, cast your shape, then pour in the skin-safe silicone. Follow the exact timing and mixing ratios to avoid a failed mold.
Why Timing and Mixing Ratios Matter
The Clone A Willy kit works by creating a two-part mold: first you make an impression of your shape, then you fill that mold with silicone. Both stages rely on precise water-to-powder ratios and quick mixing, because the materials start to set within minutes.
If you mix too little or too much powder, the mold may be too soft or too brittle, and the final dildo could have air bubbles or an uneven surface. The kit includes extra molding powder in the bundle versions, which gives you a second chance if your first attempt fails.
Choosing Between Glow-in-the-Dark and Skin Tone
The glow-in-the-dark editions add a fun visual twist, but the color doesn't change the molding process. They work exactly the same as the skin-tone version, so your choice comes down to whether you want a realistic look or a party-ready glow.
Keep in mind that glow-in-the-dark material needs exposure to light to charge. If you plan to use it in a dark room, give it a few minutes under a lamp first.
Step-by-Step Clone A Willy Instructions
- Prepare your workspace and materials: Lay down newspaper or a plastic sheet, have the mixing cup, stirring stick, molding powder, and water ready. Read the entire instruction sheet before starting. Check that you have at least 30 minutes of uninterrupted time—once you mix, you can't pause.
- Mix the molding powder with water: Use the exact water temperature and amount specified in the kit. Stir quickly but avoid whipping air into the mixture. Common mistake: using cold water can slow the set, but too warm can cause it to set too fast. Set a timer for the recommended mixing time and stick to it.
- Insert your shape into the molding mixture: Hold your shape steady in the center of the mold while it sets. Do not move it until the material is fully firm to avoid a distorted impression. If you're using a partner, agree on a signal to stay still for the full setting time.
- Remove the original shape and mix the silicone: Carefully pull the original shape out of the mold. Mix the silicone components in the provided cup, following the ratio and mixing time exactly. Overmixing can introduce bubbles. Pour the silicone in a thin stream to help reduce air pockets.
- Pour the silicone and let it cure: Pour the mixed silicone into the mold, filling it completely. Let it cure for the recommended time—typically several hours—before demolding. Be patient: removing it too early can ruin the shape.
- Demold and clean your finished dildo: Gently peel the mold away from the cured silicone. Wash the dildo with mild soap and water before first use. Store it away from direct sunlight and other silicone toys to prevent degradation.
Clone A Willy Bundle Options
-
Clone A Willy Bundle Glow In The Dark Blue: The Glow in the Dark Blue Edition includes the glow-in-the-dark kit plus extra molding powder. The extra powder gives you a backup batch if your first mold doesn't set correctly, making it a good choice for beginners.
Clone A Willy Bundle Glow In The Dark Blue
-
Clone A Willy Bundle Light Skin Tone: The Light Skin Tone bundle includes the Clone-A-Willy Kit in Light Tone plus additional molding powder. This option creates a more realistic look, and the extra powder helps you perfect your technique without buying a second kit.
Clone A Willy Bundle Light Skin Tone
-
Clone A Willy Bundle Glow In The Dark Green: The Glow in the Dark Green Edition comes with the glow-in-the-dark kit and extra molding powder. If you want a unique color that stands out, this version delivers, and the extra powder supports trial-and-error.
