Quick answer

To display Gundam Barbatos with the Boomerang Mace effectively, balance the figure's weight on a sturdy base, attach the mace at a dynamic angle, and use the included cape to create dramatic silhouettes.

Why the Boomerang Mace changes the display rules

The Boomerang Mace is a large, asymmetrical weapon that shifts the figure’s center of gravity. Unlike standard beam sabers or rifles, this mace requires careful weight distribution to avoid tipping. The Metal Build Gundam Barbatos uses die-cast components in the frame, which add stability low in the torso and legs, but the mace’s reach can still pull the figure off balance if posed too aggressively.

Cape placement matters more than you think

The crimson-colored cape is not just a cosmetic addition—it visually anchors the figure and hides the stand or base when used correctly. Drape it over the shoulders and let one end fall behind the mace arm to create a flowing line that guides the viewer’s eye from the head down to the weapon. Avoid bunching the cape around the neck joint, as it can restrict head articulation.

Step-by-step display setup

  1. Choose a stable base: Place the figure on a flat, non-slip surface. If using a stand, attach the support arm to the waist or back—never the legs, as the mace's length can tip the figure forward. A stand with a wide claw grip works best for this figure.
  2. Attach the Boomerang Mace: Slide the mace into the right hand grip. Rotate the wrist joint so the mace points diagonally upward or outward—not straight forward—to keep the center of gravity over the feet. Test the balance before letting go. Aim for a 30–45 degree angle from vertical to avoid tipping.
  3. Adjust the cape for visual flow: Drape the cape over the left shoulder and let it cascade behind the right arm that holds the mace. This creates a diagonal line that emphasizes the weapon's reach. Ensure the cape does not cover the mace head. Use a small clear pin or tack to hold the cape in place if it slides.
  4. Pose the legs for counterbalance: Spread the legs shoulder-width apart and slightly bend the knees. Rotate the left foot outward for a wider stance. This distributes the weight evenly and supports the mace's off-center pull. Check that both feet are flat on the surface—no floating heels.
  5. Fine-tune the head and arms: Turn the head to face the mace direction, as if Gundam Barbatos is about to strike. Keep the left arm slightly raised or bent at the elbow to balance the silhouette. Avoid crossing the arms over the chest, which hides the die-cast frame detail. The head should not be twisted past 90 degrees to avoid stressing the neck joint.

About the figure