Quick answer
To pose your Gundam Barbatos Lupus Rex figure, start by identifying the die-cast joints that bear weight, then attach the super-large mace last to avoid tipping. Use the metallic pearl finish as a photography asset by diffusing light rather than pointing a flash directly at it.
Understanding the figure’s unique build
The Metal Robot Spirit Gundam Barbatos Lupus Rex Limited Color Edition is roughly 150 mm tall and combines plastic with die-cast metal parts. The die-cast sections add heft to the torso and legs, which improves stability but also means the figure is heavier than a standard plastic action figure. You need to account for this weight when choosing a pose, especially if you plan to display it on a shelf that might get bumped.
The metallic pearl gloss finish on every part is a highlight of this edition, but it also makes fingerprints and dust more visible. Handle the figure with clean, dry hands or wear cotton gloves. If you must touch the painted surfaces, hold it by the die-cast joints or the base of the mace handle rather than the painted armor plates.
Step-by-step posing guide
- 1. Warm up the joints before posing: Run the die-cast joints under warm tap water for 30 seconds or use a hairdryer on low heat from 12 inches away. This softens any factory-tight plastic sleeves around the metal pins and prevents stress marks. Twist each joint gently through its full range of motion once, then let the figure cool to room temperature. If a joint feels stuck, do not force it. Repeat the warming step instead of risking a cracked peg.
- 2. Choose a stable base pose first: Set the figure on its included stand or on a flat, non-slip surface. Spread the feet shoulder-width apart and angle the toes slightly outward. Bend the knees just a few degrees and lower the hips to create a grounded center of gravity. This stance supports the die-cast torso without the figure tipping forward. Avoid full crouches or one-legged poses unless you use the stand, because the die-cast weight makes the figure unstable on its own.
- 3. Position the arms and eye effect before the mace: Attach the eye effect part to the head first if you want the runaway-state look. Then pose both arms symmetrically or asymmetrically depending on the action you want. For a two-handed mace swing, bring both hands toward the chest. For a one-handed carry, angle the non-mace arm outward for visual balance. Lock the shoulder and elbow joints firmly before adding the weapon. Check that the eye effect does not press against the face plate or restrict head movement; it should sit loosely in the socket.
- 4. Attach the super-large mace last: Slide the mace handle into the right hand (or both hands) until you hear a click. The mace is heavy enough to pull the figure forward, so tilt the upper body backward slightly and shift the rear foot back an extra centimeter. If the figure still leans, use the stand’s arm to support the mace shaft rather than the figure itself. Do not leave the mace in the grip for weeks on end without checking the wrist joint; the constant weight can loosen the peg over time.
- 5. Fine-tune the silhouette for display: Step back three feet and look at the figure’s outline. Adjust the head to face the direction of the mace swing, and rotate the waist to add a twisting motion. For the metallic pearl paint to pop, position a soft light source (like a desk lamp with a white shade) at a 45-degree angle above and to the side of the figure. Avoid direct overhead light, which washes out the pearl sheen. If you photograph the figure, use a plain white or black background and a tripod to keep the camera steady at the figure’s eye level.
Product facts
-
Gundam Metal Robot Spirit Gundam Barbatos Lupus Figure Rex - Limited Color Edition: Each part is painted with metallic pearl gloss, and the base uses special metallic red foil stamping. The glossy finish reflects light beautifully for photography, but it also shows smudges easily, so you should handle the figure by its die-cast joints or wear gloves.
Gundam Metal Robot Spirit Gundam Barbatos Lupus Figure Rex - Limited Color Edition
-
Gundam Metal Robot Spirit Gundam Barbatos Lupus Figure Rex - Limited Color Edition: The set includes an overwhelmingly voluminous super-large mace and an eye effect that reproduces the runaway state. The large mace adds dramatic posing possibilities but shifts the figure’s center of gravity forward, so you must attach it last and sometimes tilt the figure backward to compensate.
