Quick Answer
To fit a Tac Collar correctly, measure your dog's neck, adjust the collar to allow two fingers to fit snugly under it, and check that the hardware sits properly without pinching.
Why Fit Matters for a Tactical Collar
A tactical collar is built for durability and function, but a poor fit can cause chafing, slipping, or even injury. Unlike a flat buckle collar, tactical collars often have thicker material and more hardware, so getting the size right is essential.
The Original Tac Collar 1.75" and the Tac 2 Collar 1.75" are two popular options, and while they share a similar width, they differ in hardware. The Tac 2 uses only two pieces of hardware, which gives you more loop attachment area for patches or ID. This design difference can affect how the collar sits on your dog's neck, so fitting steps may vary slightly.
Step-by-Step Fitting Guide
- Measure your dog's neck: Use a flexible tape measure around the base of the neck, where the collar will naturally rest. Keep it snug but not tight. Add 2-3 inches to this measurement to find the correct collar size. If your dog is between sizes, choose the larger size for comfort.
- Adjust the collar length: Loosen the buckle or slider to its largest setting, then place the collar around your dog's neck. Tighten it gradually until it fits snugly, but you can still slide two fingers flat underneath. Check that the collar is not too loose—you should not be able to pull it over your dog's head easily.
- Position the hardware: For the Original Tac Collar, ensure the three hardware pieces sit evenly and don't dig into the neck. For the Tac 2, the two hardware pieces should be centered under the chin and at the back, leaving the loop area free for attachments. If a hardware piece presses against the throat, adjust the collar slightly higher or lower.
- Test the fit with a walk: Take your dog on a short walk and observe how the collar behaves. It should stay in place without rotating or sliding. Check for any signs of chafing or rubbing after a few minutes. If the collar rotates, tighten it slightly; if it chafes, loosen it a bit.
- Perform a safety check: Ensure the collar is not too tight—you should be able to fit two fingers between the collar and your dog's neck. Also, check that the buckle or quick-release mechanism works smoothly and that there are no loose threads or damaged hardware. Re-check the fit every few weeks, especially if your dog is still growing or changes weight.
Product Facts
-
Original Tac Collar 1.75": The Original Tac Collar 1.75" was K9TG's first tactical collar design, constructed to be put to the test. Its rugged construction means you need a snug fit to prevent movement that could cause wear or discomfort during rigorous activities.
Original Tac Collar 1.75"
-
Tac 2 Collar 1.75": The Tac 2 Collar 1.75" uses only two pieces of hardware rather than three, allowing more room for personalization with more loop attachment. The reduced hardware changes the balance and flexibility, so you may need to adjust the fit slightly differently to keep it centered and secure.
Tac 2 Collar 1.75"
