Quick answer
Remove the old harness, thread the new Lithe Double Harness Strips through the seat slots, and secure the covers. This guide walks you through each step for a snug fit.
Why replace the harness strips and covers
Over time, stroller harnesses can wear out from frequent use and exposure to sunlight or spills. The Lithe Double Harness Strips with Covers Set is designed specifically for the Mompush Lithe V2 and Lithe Double strollers, ensuring a proper fit and continued safety. Replacing them restores the harness’s strength and keeps your child comfortable.
Before you start
Make sure you have the correct replacement part for your stroller model. The Lithe Double Harness Strips with Covers Set fits the Lithe V2 and Lithe Double only. Check your stroller’s model number before purchasing. You’ll need a small flathead screwdriver or a similar tool to pry open the buckle clips if they are stuck.
Installation steps
- Remove the old harness: Unbuckle the chest clip and crotch buckle. Locate the anchor points on the back of the seat and slide the straps out. Use a screwdriver to gently pry open any stuck clips. Common mistake: Pulling the strap without releasing the clip can damage the seat fabric. Always check for clips first.
- Thread the new harness strips: Insert the shoulder straps through the top slots from the back of the seat. Route the lap straps through the side slots. Ensure the straps are not twisted and lie flat against the seat. Checkpoint: Verify the straps are on the correct side (left/right) before tightening. Twisted straps reduce harness effectiveness.
- Attach the harness covers: Slide the padded covers over the shoulder straps. Position them so they sit comfortably on your child’s shoulders without bunching. Secure any Velcro fasteners. Common mistake: Placing the cover too high or low can cause discomfort. Adjust so the cover sits at the shoulder level when buckled.
- Connect the buckles and test fit: Click the chest clip and crotch buckle together. Adjust the strap length using the sliding adjusters. Tug on each strap to ensure it holds firmly. Checkpoint: The harness should be snug but not tight. You should be able to fit two fingers between the strap and your child’s chest.
What you need
-
Lithe & Lithe Double Harness Strips with Covers Set: 5 Point Harness Straps-Made of sturdy and durable material, non-toxic and odorless Non-toxic and odorless material ensures your child’s safety and comfort, even during long strolls.
Lithe & Lithe Double Harness Strips with Covers Set
