Quick answer
Installing the Slide 22x8 on a Cat Condo or Cat Mansion takes about 15 minutes with a Phillips screwdriver. The key is to align the slide brackets with the existing holes on your cat tree and tighten all screws evenly.
Before You Begin: What You Need
The Slide 22x8 is a spare component designed specifically for the Cat Condo and Cat Mansion models from Cat Tree King. It replaces an existing component, so you will be removing a part before adding the slide.
You will need a Phillips head screwdriver (not included). No additional tools or hardware are required because the slide comes with all necessary screws and brackets. Work on a flat, stable surface to prevent the cat tree from tipping during installation.
Common Installation Mistakes to Avoid
The most frequent error is over-tightening the screws, which can strip the pre-drilled holes in the particleboard. Turn screws until snug, then stop. Another mistake is misaligning the slide brackets with the existing holes. Always test-fit the slide before inserting any screws.
If your cat tree has been assembled for a while, the original screws may be stuck. Use a screwdriver with a good grip and apply steady pressure. Do not force the slide into a position that does not align naturally; it is designed to fit only specific connection points.
Installation Steps
- Remove the Existing Component: Unscrew the component you are replacing (e.g., a platform or ramp) from the Cat Condo or Cat Mansion. Keep the screws aside; you may reuse them if they match the slide brackets. Set the removed part aside. Common mistake: Trying to install the slide without removing the old part first. The slide will not fit over an existing component.
- Position the Slide Brackets: Hold the Slide 22x8 against the open connection points on your cat tree. Align the pre-drilled holes on the slide brackets with the holes on the cat tree frame. The slide should sit level and flush against the frame. Checkpoint: If the holes do not line up, rotate the slide 180 degrees. The slide is symmetrical but the brackets may be oriented differently.
- Insert and Tighten Screws: Insert the screws provided with the slide through the brackets and into the cat tree holes. Tighten each screw by hand until it is snug, then give a quarter turn with the screwdriver. Do not overtighten. Common mistake: Overtightening can strip the holes. If a screw spins freely, stop and try a different hole or use a toothpick with wood glue to fill the stripped hole before reinserting.
- Test the Slide Stability: Gently push down on the slide to ensure it is firmly attached. The slide should not wobble or shift. If it moves, check that all screws are tight and the brackets are fully seated. Checkpoint: A loose slide can tip when your cat jumps on it. Re-tighten any loose screws before letting your cat use it.
- Let Your Cat Explore: Once the slide is secure, place your cat on the cat tree near the slide. Encourage exploration with a treat or toy. Supervise the first few uses to ensure your cat uses the slide safely. Common mistake: Forcing your cat onto the slide. Let them approach at their own pace; some cats need a few days to trust a new component.
Product Details
-
Slide 22 x 8, Cat Condo & Cat Mansion (Beige): This is a slide for the Cat Condo and Cat Mansion from Cat Tree King. It is a spare component that you can reorder to replace a current cat tree component. You do not need to buy a whole new cat tree to add a slide; you simply swap out an existing part, saving money and reducing waste.
Slide 22 x 8, Cat Condo & Cat Mansion (Beige)
