Quick Answer
Mount the Blade-Tech OWB holster on a sturdy belt at 3 or 4 o'clock using the Tek-Lok belt clip, then confirm the barrel protector and safety cover sit correctly before you ever draw. Build your draw in slow, deliberate repetitions: grip, defeat retention, clear the holster, and keep the device pointed in a safe direction. Speed comes only after the motion is consistent.
Why the Blade-Tech OWB Holster Suits TASER Pulse Carry
The Blade-Tech OWB holster is a Kydex outside-the-waistband option built for the TASER Pulse series. Its Tek-Lok belt clip has been contoured to better fit the profile of the body and reduce hot spots, which matters when you wear it for hours rather than minutes. Two safety features are worth understanding before mounting: a barrel protector that stops darts in case of accidental misfire, and a safety cover over the device. Those features only work if the device is seated fully and the holster is positioned correctly.
Position the Holster on a Real Belt
OWB carry depends on belt quality more than most people expect. A flimsy dress belt lets the holster sag and shift, which changes your draw angle every time. Thread the Tek-Lok onto a stiff belt and set the holster behind your hip, roughly at 3 or 4 o'clock for a right-handed draw. If you carry a phone or keys on that side, move them to the opposite pocket so nothing blocks the grip.
Seat the Device and Verify the Safety Features
With the holster mounted, insert the TASER Pulse until it stops. Check that the barrel protector covers the cartridge area and the safety cover sits where it should. Then do a retention test: turn the holster upside down over a soft surface and confirm the device does not fall free. Retention should be firm but not so tight that you cannot draw one-handed.
Build the Draw in Slow Repetitions
Start with an unloaded device or a training setup and practice the draw in four stages. First, get a full firing grip with your thumb and fingers in the same place every time. Second, defeat the retention and pull straight up until the device clears the holster mouth. Third, bring the device to a low-ready position pointed in a safe direction. Fourth, reholster slowly, watching the device into the holster rather than looking away. Reholstering is where most avoidable mistakes happen, so never rush it.
Mount and Draw Steps
- Choose a stiff belt and a clear carry position: Thread the Tek-Lok onto a belt that will not fold under the holster's weight. Set the holster at 3 or 4 o'clock and clear that side of your pockets. Checkpoint: with the empty holster on, bend, sit, and reach overhead. If the holster shifts more than slightly, tighten the belt or reposition.
- Seat the device and test retention: Insert the TASER Pulse series device until it stops, confirm the barrel protector and safety cover are in place, then turn the holster upside down over a soft surface. Checkpoint: the device should stay put with a gentle shake but release with a firm, straight pull.
- Practice the four-stage draw slowly: Grip, defeat retention, clear the holster, and pause at low ready. Then reholster while watching the device into the holster. Checkpoint: if your grip changes between reps, slow down. Consistency before speed.
- Add a dry-fire routine with a safe backstop: Once the draw is smooth, practice presenting and pressing the activation switch with the device unloaded and pointed at a safe backstop. Next step: live-fire practice belongs at a range or training area, not in your living room.
Product Facts
- Blade-Tech OWB Holster: Blade-Tech OWB Kydex holster with a universal belt clip, a newly remodeled Tek-Lok contoured to fit the body profile and reduce hot spots, a barrel protector to stop darts in case of accidental misfire, and a safety cover. Compatible with the TASER Pulse series. The Tek-Lok contouring reduces pressure points during long wear, while the barrel protector and safety cover add a layer of protection that only works if the device is fully seated.
