Quick Answer
To replace the temple piece on your LightAura Plus, gently detach the worn piece from the mask frame and snap the new one into place. Ensure it clicks securely before your next session.
Why a Secure Temple Piece Matters
A properly fitted temple piece keeps your LightAura Plus mask stable during treatment, so the LEDs stay at the correct distance from your skin. If the piece is loose or worn, the mask may shift, reducing the effectiveness of your session.
The temple piece is a small but critical part of the mask's fit system. Over time, daily use and cleaning can cause it to stretch or lose its grip, making replacement a routine part of mask maintenance.
When to Replace Your Temple Piece
Inspect your temple piece regularly—at least once a month. If you notice it no longer holds the mask snugly against your face, or if it shows visible cracks or wear, it's time for a replacement.
Replacing the temple piece is a quick, low-cost fix that can extend the life of your mask and keep your sessions comfortable. It's a simple DIY repair that doesn't require special tools.
Step-by-Step Replacement Guide
- Prepare your mask: Remove the LightAura Plus mask from any power source and lay it on a clean, flat surface. This prevents accidental activation and gives you a stable work area. Always disconnect power before handling parts.
- Remove the old temple piece: Gently pull the existing temple piece away from the mask frame. It should detach with light pressure. If it resists, check for any locking tabs and press them inward while pulling. Don't force it—excessive force can damage the frame.
- Align the new temple piece: Take one of the new temple pieces from the pair and align it with the mounting point on the mask. Ensure the curved side faces outward and the attachment points line up with the frame. Double-check the orientation before snapping it in.
- Snap the new piece into place: Press the temple piece firmly onto the frame until you hear a click. This indicates it is securely seated. Repeat on the other side if you are replacing both. Listen for the click—it confirms a secure fit.
- Test the fit: Put on the mask and adjust the straps. The temple pieces should hold the mask snugly without pressing too hard. If the mask shifts, recheck the attachment. A proper fit means no slipping during your session.
What You Need
-
Temple Piece for LightAura Plus | 1 Pair | Parts: This pair of temple pieces is designed as a direct replacement for the LightAura Plus LED face mask, helping to keep the mask securely positioned on your face. Using the correct replacement part ensures a proper fit, so your mask stays in place and delivers consistent light therapy.
Temple Piece for LightAura Plus | 1 Pair | Parts
