Quick Answer
To set up the SANDMARC Titanium Edition Apple Watch Ultra Band, remove your current band, slide the titanium links into the watch lugs until they click, then adjust the clasp for a snug fit.
Why the Titanium Band Fits Differently
Unlike silicone or nylon bands, the SANDMARC Titanium Edition uses a link-based design inspired by mechanical watch bracelets. This means you'll need to remove links to size the band before wearing—a common step that first-time buyers might overlook.
The DLC-coated titanium is lightweight and corrosion-resistant, so you don't have to worry about water exposure during setup or everyday wear. However, the link pins require a bit of patience the first time.
Step-by-Step Setup Instructions
- Remove your current band: Press and hold the band release button on the back of your Apple Watch Ultra, then slide the existing band out sideways. Repeat for the other side. Make sure the watch face is facing down on a soft cloth to avoid scratches.
- Attach the titanium band: Align the titanium link connector with the watch lug groove. Slide it in until you hear a click. Repeat on the other side. The band should sit flush with no gap. If the band doesn't click, check that you're using the correct orientation—the SANDMARC logo should face outward.
- Size the band by removing links: Lay the band flat and locate the small arrows on the underside of the links. Use the pin-pusher tool to push out the pins in the direction of the arrow. Remove equal links from both sides to keep the clasp centered. Only remove one link at a time and test the fit. It's easier to remove more than to add back a lost pin.
- Adjust the clasp for final fit: Close the clasp and slide the micro-adjustment holes on the folding buckle to fine-tune the tightness. Aim for a fit that allows one finger to slide under the band. The titanium band shouldn't pinch your skin. If it does, add one link back or loosen the micro-adjustment.
Product Details
-
Titanium Edition - Apple Watch Ultra Band: The SANDMARC Titanium Band is built from DLC-coated titanium that is waterproof, lightweight, and corrosion resistant. It uses a link-and-pin system rather than magnets or loops. You'll need a small pin-pusher tool (often included) to remove links for sizing, and the metal construction means the band stays secure during swimming or workouts.
Titanium Edition - Apple Watch Ultra Band
