Quick answer
To use conductive loops for e-stim, attach them to your electro box, adjust the fit snugly around the penis or balls, and start with the lowest power setting, increasing gradually.
Why choose conductive loops over pads or plugs
Conductive loops offer a targeted, adjustable contact point for electro stimulation, especially around the genitals. Unlike sticky pads that lose adhesion with sweat or movement, loops stay put once tightened. They also let you vary the sensation by changing the loop's position or tightness, which is harder with a fixed electrode.
What to look for in a conductive loop
The 2mm Conductive Loops from Regulation are made from soft, flexible conductive rubber that's comfortable against sensitive skin. They feature a built-in slider for adjusting tightness, and the standard 2mm connection fits most electrostim boxes. The rubber material also resists slipping, so the loop stays where you place it even during active play.
Step-by-step guide to using conductive loops
- 1. Prepare your gear: Connect the conductive loop to your electrostim box using the 2mm lead. Apply a small amount of water-based conductive gel to the loop's contact surface for better signal transfer and reduced discomfort. Don't skip the gel – dry rubber can cause hot spots or uneven sensation.
- 2. Position the loop: Slide the loop around the base of the penis, behind the testicles, or around the glans, depending on the sensation you want. Use the built-in slider to tighten it until it's snug but not pinching. The loop should stay in place without constant adjustment. Too tight can cut circulation; too loose will lose contact and cause uneven zaps.
- 3. Start low and go slow: Turn on your electro box and set the intensity to the lowest setting. Press a button or pulse the signal briefly to test the sensation. If comfortable, increase the power in small increments. Never max out the dial immediately. A sharp pain means you're too high or the gel has dried – back off and reapply gel.
- 4. Experiment with placement: Once comfortable, try moving the loop to different spots – around the glans, just behind the corona, or encircling both testicles. Each position produces a different type of pulse or buzz. You can also use two loops (one on the penis, one on the scrotum) for a more complex sensation. Always turn the power down before repositioning the loop to avoid accidental shocks.
- 5. Clean and store properly: After play, remove the loop from the box and wash it with warm water and mild soap. Let it air dry completely before storing. Do not use alcohol or harsh cleaners that can degrade the conductive rubber. Residue from gel or lube can make the loop sticky or less conductive over time.
Product facts
-
2mm Conductive Loops: Made for teasing/hurting his cock and balls; easily adjustable with a built-in slider; soft, flexible conductive rubber; standard 2mm connection compatible with plenty of electrostim boxes. The adjustable slider lets you fine-tune the pressure for comfort or intensity, and the standard connector ensures it works with most e-stim power boxes you already own.
2mm Conductive Loops
