Quick answer
Mount a universal headphone hook on your sim rig by sliding a T-nut into your aluminium profile slot, then bolting the hook to the profile using the supplied hardware.
Why a dedicated hook beats a DIY solution
A universal headphone hook like the Trak Racer model is machined to fit standard T-slot profiles without modification. DIY hooks often require drilling or adhesive that can damage the profile's anodized surface or leave residue. The dedicated hook also supports the weight of a steering wheel if you want to store it off the rig.
Step-by-step installation guide
- 1. Choose the mounting location: Pick a spot on your rig's upright or cross-member profile where the hook won't interfere with your seating position or wheel movement. Common choices are the side upright near the seat or the front crossbar below the wheel deck. Test the clearance by holding the hook in place before tightening anything.
- 2. Insert the T-nut into the profile slot: Slide a T-nut (usually M6 or M8, depending on your profile's slot size) into the T-slot channel at your chosen location. Orient the nut so its threaded hole faces outward. Most profile slots accept the nut from the open end of the extrusion. If the T-nut is loose, check that you're using the correct size for your profile's slot width.
- 3. Align the hook bracket over the T-nut: Place the hook's mounting bracket against the profile so the bracket's hole aligns with the T-nut's threaded hole. The hook arm should point away from your driving position to avoid accidental bumps. Double-check the hook orientation—reversing it later means loosening the bolt.
- 4. Thread the bolt and tighten: Insert the bolt through the bracket hole and into the T-nut. Tighten it with a hex key until the bracket is snug against the profile. Do not overtighten—aluminium profile can deform under excessive force. Stop tightening as soon as the bracket cannot rotate by hand.
- 5. Test the load and adjust: Hang your headset or steering wheel on the hook. Check that the hook holds the weight without tilting or slipping. If it shifts, tighten the bolt slightly. If the hook still moves, the T-nut may be the wrong size for your profile. A properly mounted hook should support a wheel rim without the bracket rotating on the profile.
Product facts
-
Universal Headphone and Steering Wheel Hook Holder: Trak Racer Universal Aluminium Profile Headphone Hook Holder is designed specifically for aluminium extrusion (T-slot) simulator frames. It slides directly into your rig's existing slots without drilling, so you can reposition it whenever you change your cockpit layout.
Universal Headphone and Steering Wheel Hook Holder
