Quick Answer

To replace the battery in your Neato Botvac D7 or compatible model, use a 6800mAh replacement from CELLONIC and follow the simple steps below. Always power off the robot and remove the battery before any maintenance.

Why Choose a 6800mAh Replacement?

The original Neato batteries typically have a lower capacity, so upgrading to a 6800mAh replacement can extend your robot's runtime between charges. This is especially useful for larger homes or if you run multiple cleaning cycles per day.

The CELLONIC replacement is designed for Neato Botvac Connected, D7 Connected, D3, D5 Plus, and D703 models, offering a drop-in fit without any modification.

Safety First: Precautions Before You Start

Always turn off the robot and unplug the charger before removing the battery. Work on a soft, flat surface to avoid scratching the robot's sensors or bumpers.

Do not use metal tools to pry the battery out—use your fingers or a plastic spudger to avoid shorting the contacts.

Step-by-Step Battery Replacement

  1. Power Off and Unplug: Turn off the robot using the power button and unplug the charging dock. Place the robot upside down on a soft surface. Ensure the robot is completely off before proceeding to avoid electrical shock.
  2. Remove the Battery Cover: Locate the battery compartment on the bottom of the robot. Use a screwdriver to remove the screws holding the cover, then lift the cover off. Keep the screws in a safe place so you don't lose them.
  3. Disconnect and Remove the Old Battery: Gently pull the connector to unplug the old battery from the robot's motherboard. Lift the battery out of its compartment. Do not pull on the wires—only pull the connector itself to avoid damage.
  4. Insert the New Battery: Place the new CELLONIC battery into the compartment, aligning the connector. Push the connector firmly until it clicks into place. Double-check that the connector is fully seated to ensure power flows correctly.
  5. Reattach the Cover and Charge: Replace the battery cover and tighten the screws. Turn the robot right side up, place it on the dock, and allow it to charge fully before first use. A full charge cycle helps calibrate the battery for optimal performance.