Quick answer
Use Tatti Lashes Brush On Lash Adhesive by applying a thin, even layer to the lash band, waiting 30 seconds for it to become tacky, then pressing the strip onto your natural lash line for a secure, long-lasting hold.
Why Brush-On Adhesive Works for Beginners and Experts
The brush-on applicator gives you precise control over the amount of glue, reducing mess and waste. Unlike squeeze tubes, the brush tip lets you coat the lash band evenly without overloading it, which helps prevent clumping and lifting at the edges.
This adhesive is latex-free and waterproof, making it a good choice for sensitive eyes or long wear. The formula is nontoxic and vegan-friendly, so you avoid common irritants found in some other lash glues.
Common Mistakes to Avoid
Applying too much glue is the most frequent error. A thick layer takes longer to dry and can slide off the lash band, causing the strip to lift during the day. Stick to one thin coat.
Skipping the tacky wait time is another. If you apply the lash while the glue is still wet, the strip may slip out of place. Wait until the glue feels tacky to the touch before placing it on your lash line.
How to Apply Tatti Lashes Brush On Lash Adhesive
- Prepare your natural lashes: Clean your eyelids and natural lashes with an oil-free makeup remover to remove any residue. Dry thoroughly. Oil or leftover mascara will weaken the bond. Skipping this step is the top reason lashes fall off early.
- Apply a thin layer of adhesive: Shake the bottle gently. Use the brush to apply a thin, even coat along the entire lash band. Focus on the ends, where lifting most often starts. A thick layer takes longer to set and may cause the lash to slide.
- Wait for the glue to become tacky: Hold the lash strip in the air for about 30 seconds, or until the glue feels sticky when you lightly touch it with a clean finger. Applying while wet is the most common beginner mistake.
- Position and press the lash: Place the strip as close to your natural lash line as possible. Press down gently from the center outward, holding for 10-15 seconds to secure the bond. Press the inner and outer corners firmly to prevent lifting.
- Let the adhesive cure fully: Avoid touching or blinking hard for one minute after application. The glue will continue to strengthen as it dries completely. Full cure takes about 60 seconds; rushing this can weaken the hold.
Product Details
-
Tatti Lashes Brush On Lash Adhesive: Tatti Lashes Brush On Lash Adhesive is latex-free, waterproof, suitable for sensitive skin, and not tested on animals. This makes it a safe choice for people with allergies or sensitive eyes, and it holds up through humidity or tears without losing grip.
Tatti Lashes Brush On Lash Adhesive
