Quick answer
The Kreg 90° Pocket-Hole Driver lets you drive pocket-hole screws at a right angle in tight spots where a standard driver won't fit. It works with any hex shank bit and is impact-rated for heavy use.
Why a right-angle driver matters for pocket-hole joinery
Standard drill drivers often can't reach pocket holes drilled near cabinet sides, inside frames, or under shelves. The 90° Pocket-Hole Driver solves that by angling the bit 90 degrees, giving you access without removing the workpiece.
Trade-offs to consider
The 90° adapter adds length and weight compared to a standard bit. It also limits your torque slightly because of the gear mechanism. For most pocket-hole screws, this isn't an issue, but for very dense hardwoods, you may need to pre-drill or use a slower speed.
How to use the Kreg 90° Pocket-Hole Driver for right-angle joinery
- 1. Attach the driver to your drill or impact driver: Insert any hex shank bit into the 90° Pocket-Hole Driver's collet and tighten the collar. Then insert the driver's hex shank into your drill or impact driver chuck. Ensure it is fully seated and secure. Common mistake: not tightening the collar enough, causing the bit to slip during driving.
- 2. Align the driver with the pocket hole: Position the 90° driver so the bit enters the pocket hole at a right angle. The ergonomic grip helps you maintain control. For angled pocket holes (e.g., 15°), adjust the driver angle slightly to match the hole's entry angle. Common mistake: forcing the bit into the hole at the wrong angle, which can strip the screw head or damage the pocket.
- 3. Drive the screw: Apply steady, gentle pressure and squeeze the trigger. Let the driver do the work. The magnetic tip holds the screw in place, so you don't need to hold it with your other hand. Drive until the screw head is flush with the workpiece surface. Common mistake: driving too fast or with too much pressure, which can cause the screw to over-torque or break.
Product facts
-
90° Pocket-Hole Driver: Drive screws in tight spaces with any hex shank bit. Perfect for pocket-hole screws. Included 3” square-drive magnetic-tip bit locks in, won’t fall out. Ergonomic, easy-grip design. Impact rated. You can use your existing hex bits, and the magnetic tip keeps the screw from dropping during angled driving. The impact rating means it handles repeated use without breaking.
90° Pocket-Hole Driver
