Quick answer

The Joovy Zoom Rain Cover fits only the Jet or Slate Zoom single jogging stroller. Install it by securing the top over the canopy, then fastening the bottom around the frame, and finally checking that all openings are sealed.

Why fit matters for this rain cover

A rain cover that doesn't fit tightly can let water in through gaps around the canopy or foot area. The Zoom Rain Cover is custom-made for the Jet and Slate Zoom single strollers, so it should contour closely to those frames. If you try to use it on a different stroller model, the fit will be loose and the protection unreliable.

Before you start, confirm that you have a Zoom single jogger (not a double or a different Joovy stroller). The cover's elastic hem and corner pockets are shaped specifically for that frame.

Installation steps

  1. Step 1: Position the cover over the canopy: Unfold the rain cover and drape it over the stroller's fully extended canopy. Align the seamed top edge with the front of the canopy. The elastic should sit just behind the canopy's peak. Common mistake: placing the cover too far forward so it doesn't reach the handlebar area. Adjust so the back edge hangs evenly.
  2. Step 2: Secure the bottom hem around the frame: Pull the elastic hem down around the stroller's frame, just above the wheels. Tuck any excess fabric under the seat or footrest so it doesn't flap. The cover should be snug but not stretched tight. Check that the elastic is fully around the frame and not caught on a brake cable or wheel. A gap here lets water splash in.
  3. Step 3: Fasten any corner straps or pockets: If your cover has small corner pockets, slide them over the stroller's front corners. Some versions have hook-and-loop straps near the handlebar—wrap those around the frame and secure them. Skipping this step allows the cover to shift in the wind, creating openings at the corners.
  4. Step 4: Check the canopy opening seal: Make sure the cover's front flap lies flat against the canopy's visor. If there is a zippered window, close it completely. The cover should not sag onto your child's face. A common oversight is leaving the window unzipped, which lets rain drip inside.
  5. Step 5: Test for fit and airflow: Open and close the stroller's canopy with the cover on. The cover should move with the canopy without pulling off. Leave a small gap at the back for airflow if the cover has a mesh vent—otherwise, crack the window slightly. If the cover restricts canopy movement, it is not seated correctly. Recheck the bottom hem tension.

Product facts

  • Zoom Rain Cover: Custom fit for the Jet or Slate Zoom jogging stroller only. Using it on any other stroller will leave gaps that defeat the purpose of a rain cover.

    Zoom Rain Cover

    Zoom Rain Cover