Quick answer
To set up the Tartarus bundle with 90-degree cables, connect the cables to the stimulator and your chosen electrode, then power on and adjust intensity gradually. This guide walks you through each step and highlights common setup mistakes.
Why 90-degree cables matter
The 90-degree cables in this bundle are designed for tight or awkward setups, where straight cables might bend or pull on connectors. They reduce strain on the cable and device ports, helping maintain a reliable connection during use.
Check compatibility before starting
The Tartarus device works with ElectraStim's standard electrode range. Before connecting, verify that your electrode or probe has a compatible 2 mm pin connector. Most ElectraStim dildos, probes, and cock rings are compatible, but third-party accessories may not fit.
Step-by-step setup
- 1. Inspect the bundle contents: Unpack the Tartarus stimulator and the two 90-degree cables. Check that both cables have intact pins and no visible damage. Common mistake: assuming the cables are interchangeable with non-90-degree cables—they are not, and forcing a straight cable into a tight bend can damage the connector. Damaged cables can cause intermittent power or no output. Replace any cable with bent pins immediately.
- 2. Connect the cables to the stimulator: Plug one end of a 90-degree cable into the output port on the Tartarus. The 90-degree bend should face away from the device to reduce strain. Common mistake: inserting the cable at an angle or forcing it—always push straight in until you feel a click. A loose connection can cause arcing or reduce stimulation intensity. Ensure the cable is fully seated.
- 3. Attach the electrode or probe: Connect the other end of the cable to your chosen electrode (e.g., a dildo, probe, or cock ring). Use the 90-degree bend to route the cable away from the body for comfort. Common mistake: routing the cable across a joint or area that moves—this can pull the connector loose during play. For anal probes, route the cable along the buttock to keep it secure and out of the way.
- 4. Power on and test: Turn on the Tartarus stimulator and start at the lowest intensity setting. Gradually increase until you feel the desired sensation. Common mistake: starting at a high level—this can cause discomfort or a sudden jolt. Always begin low and ramp up slowly. If you feel nothing at low levels, check all connections and ensure the electrode is properly positioned against skin.
- 5. Adjust cable position for movement: Once connected, move the 90-degree cable to a position that allows free movement of your body or your partner’s body. The bend helps keep the cable flat against the skin. Common mistake: leaving the cable dangling—this can snag on clothing or bedding and disconnect the setup. Use medical tape or a cable clip to secure the cable to your body or clothing if needed.
Product facts
-
Bundle: Tartarus and 2 x 90 Degree Cables: This bundle pairs the Tartarus electro-sex toy with two 90-degree cables, offering a convenient setup for your play. By purchasing them together, you save 25% off one set of cables. Buying the bundle saves money and ensures you have the right cables for flexible connection right out of the box.
Bundle: Tartarus and 2 x 90 Degree Cables
