Quick answer
Assemble Plastic Cavalry Bases Set 7 by preparing the bases, applying plastic glue, and fitting each base onto a VXB004 Cavalry Movement Tray for a secure, uniform wargame unit.
Why the right base matters for cavalry units
Cavalry bases are wider than infantry bases to accommodate horse models and provide stability. The Plastic Cavalry Bases Set 7 includes 48 bases, each 50mm long, giving you enough for a full unit. Using the correct base size ensures your models rank up properly on movement trays and stay aligned during gameplay.
Step-by-step assembly guide
- 1. Prepare your workspace and materials: Lay out the Plastic Cavalry Bases Set 7, your cavalry models, a bottle of plastic glue, and a clean, flat surface. Check that each base is free of flash or mold lines. A common mistake is using super glue instead of plastic glue – plastic glue melts the plastic for a stronger bond.
- 2. Test-fit each model on its base: Place a cavalry model on a base to see where the hooves contact the plastic. Mark the hoof positions lightly with a pencil if needed. If the model rocks, trim any excess plastic from the hooves with a hobby knife before gluing.
- 3. Apply plastic glue to the base: Squeeze a thin line of plastic glue onto the base where the hooves will sit. Do not flood the base – a small amount is enough. Too much glue can warp the base or create a messy finish. Less is more.
- 4. Press the model onto the base: Position the model so its hooves align with the glue. Hold it firmly for 10–15 seconds until the glue sets. Wipe away any excess glue with a paper towel. Moving the model after pressing can weaken the bond. Let it cure fully before handling.
- 5. Repeat for all models in the unit: Assemble each cavalry model onto its own base. Work in batches to speed up the process, but allow each base to dry before stacking. Stacking wet bases can cause them to stick together or deform. Wait at least 30 minutes between layers.
- 6. Fit assembled bases onto the movement tray: Once all bases are dry, slide each one into a VXB004 Cavalry Movement Tray. The bases are designed to fit snugly without glue. If a base is too tight, sand the edges lightly. Never force it – you might break the tray.
Product fact
-
Plastic Cavalry Bases Set 7: The Plastic Cavalry Bases Set 7 provides 48 individual 28mm cavalry bases per pack, each measuring 50mm in length. This means you can base an entire cavalry unit from one pack, and the 50mm length fits standard cavalry models without overhang.
Plastic Cavalry Bases Set 7
