Quick answer

Clean the surface thoroughly, apply the decal using the wet method for repositioning, and press out all bubbles and moisture before letting it cure for 24 hours.

Why the wet method works best

Applying decals with a bit of soapy water (wet method) gives you time to slide the decal into perfect position before it sticks. Dry application is faster but leaves no room for error—once it touches, it’s stuck. For the FOX Suspension Decal Kit, which includes multiple small decals for various fork and shock models, the wet method is much more forgiving.

The kit covers models like the 32 SC, 34 SL, 36, 38, 40, and Podium forks, as well as Float SL, Float, Float X, DHX, Float X2, and DHX2 shocks. With so many pieces, taking your time pays off.

Installation steps

  1. Clean the surface: Wipe the fork leg or shock body with isopropyl alcohol and a lint-free cloth. Remove all grease, dirt, and old adhesive residue. A clean surface is essential for adhesion. Common mistake: using household cleaners that leave a film, which prevents the decal from sticking.
  2. Prepare the wet solution: Mix a few drops of mild dish soap with water in a spray bottle. Lightly mist the area where the decal will go. The soap solution lets you slide the decal into place without it bonding immediately. Checkpoint: too much soap reduces adhesion—use just enough to make the surface slippery.
  3. Position the decal: Peel the decal from its backing and place it on the wet surface. Slide it gently until it aligns with the fork or shock contour. Use a soft squeegee or credit card wrapped in a cloth to press out air bubbles and excess liquid from the center outward. Common mistake: pressing too hard on edges can cause the decal to stretch or tear—work slowly.
  4. Let it cure: Allow the decal to dry for at least 24 hours. Avoid riding or exposing the bike to rain or hose water during this time. The adhesive needs full cure time to bond properly. Checkpoint: if edges lift after drying, apply gentle heat with a hair dryer and press them down again.

What you need

  • Suspension Decal Kit: The FOX Suspension Decal Kit includes decals for all current FOX fork and shock models, such as 32 SC, 34 SL, 36, 38, 40, Podium, Float SL, Float, Float X, DHX, Float X2, and DHX2. One kit covers your entire bike’s suspension, so you don’t need to buy separate sets for the fork and shock.

    Suspension Decal Kit

    Suspension Decal Kit