Quick answer
To install the Aarke drip tray cover, align it with the drip tray on your Carbonator II or 3, press down evenly until it clicks, and check that the rubber details sit flush for easy removal later.
Why the rubber details matter
The drip tray cover has rubber details on the bottom that help it detach easily. This is a small but important feature: it prevents the cover from sticking to the tray, which can happen with metal-on-metal contact over time. When installing, make sure these rubber strips are facing down and are not pinched or folded.
If you are replacing an old cover, take a moment to wipe the drip tray clean before installing the new one. Food residue or mineral deposits can prevent the cover from sitting flat, which might cause wobbling when you place a glass on it.
Installation steps
- Remove the old cover (if present): Lift the existing drip tray cover from the tray. If it feels stuck, gently pry it up from one corner to avoid bending the metal. Check that the old cover is completely detached before proceeding.
- Clean the drip tray: Wipe the drip tray with a damp cloth to remove any residue or moisture. Dry it thoroughly to ensure a secure fit. A dry, clean tray helps the cover sit flat and prevents rust or sticking.
- Align the new cover: Position the new drip tray cover over the tray, ensuring the rubber details on the bottom are facing down and the edges align evenly with the tray's outline. Double-check alignment before pressing down to avoid a crooked fit.
- Press down evenly: Press down firmly on the center and edges of the cover until it sits flush with the tray. You should feel it settle into place. If the cover does not sit flush, lift and realign it—do not force it.
- Test the fit: Place a glass on the cover and gently rock it. The cover should not wobble. Then, try lifting the cover by its edge to ensure the rubber details allow easy removal. A stable, wobble-free fit means the installation is complete.
Product facts
-
Drip Tray Cover: Replacement drip tray cover in stainless steel with rubber details on the bottom for easy detachment. Compatible with Aarke Carbonator models II and 3. This cover is a direct replacement for your Carbonator II or 3, so you can restore a clean look and maintain the easy-removal feature without needing a new drip tray.
Drip Tray Cover
