Quick Answer
To install a cabinet lock on double doors, measure the gap between the doors, align the lock body centrally, and press firmly onto clean surfaces. The Fred Safety Double Door Block uses adhesive pads and a Squeeze-n-Lift™ release, so no drilling is needed.
Why Choose an Adhesive Lock for Double Doors
Adhesive cabinet locks are a popular choice for double doors because they require no drilling or permanent modifications. They work well on smooth, clean surfaces and can be removed without damaging the cabinet. However, they rely entirely on surface preparation and adhesive quality—if the surface is textured or greasy, the bond may fail over time.
What to Consider Before You Start
Double doors often have a small gap between them when closed. The lock must bridge that gap securely. The Fred Safety Double Door Block fits doors between 6 and 21 mm thick, so check your door thickness first. Also note that adhesive locks may not hold on uneven or painted surfaces—test the adhesion on a small area if unsure.
Step-by-Step Installation Guide
- 1. Clean the Door Surfaces: Wipe both doors where the lock will attach with a mild cleaner or rubbing alcohol. Remove all grease, dust, and residue. Let the surfaces dry completely. Skipping this step is the most common cause of adhesive failure.
- 2. Measure and Mark the Position: Close both doors and mark the centre point of the gap you want to lock. Hold the lock body against the doors to check alignment—the lock should sit evenly across both doors. If the lock is off-centre, it may not engage properly or could pull on one door.
- 3. Peel and Press the Adhesive: Remove the backing from the adhesive pads on the lock. Press the lock firmly onto the marked position, holding it in place for 30 seconds. Apply even pressure across the entire pad. Do not test the lock immediately—wait at least 24 hours for the adhesive to cure fully.
- 4. Attach the EZ-Dock™ (Optional): If your lock includes an EZ-Dock™ storage dock, clean a spot inside the cabinet or on the side and attach it using the same adhesive method. This keeps the lock out of reach when not in use. Placing the dock too close to the lock may cause accidental engagement—leave a few inches of space.
- 5. Test the Squeeze-n-Lift™ Release: After the adhesive has cured, close the doors and test the lock. Squeeze the sides and lift to open. If the lock feels loose or misaligned, reposition it following the same steps. If the lock does not hold tightly, check that the doors are within the 6–21 mm thickness range.
Product Facts
-
Fred Safety Double Door Block (x1) - Pure White: Secure double door and drawers tight with the easy-to-fit block, Fred Double Door Block, suitable for doors from 6 to 21 mm thick. This means you can use it on most standard kitchen cabinets without worrying about fit, and the one-hand Squeeze-n-Lift™ release makes opening quick even when your hands are full.
Fred Safety Double Door Block (x1) - Pure White
