Quick answer
Installing a double towel rail is a straightforward DIY project that can greatly increase your bathroom storage. This guide covers the key steps and common pitfalls, using the Wilbur Double Towel Rail as an example.
Why a double towel rail improves bathroom storage
A double towel rail holds two rows of towels, effectively doubling your hanging space without taking up extra wall area. This is especially useful in smaller bathrooms where every inch counts.
The Wilbur Double Towel Rail, crafted from mango wood with solid brass fittings, adds both function and a warm, timeless look to your bathroom.
What you'll need
Before starting, gather a drill, appropriate wall anchors (if not mounting into studs), a level, a pencil, and a screwdriver. The Wilbur rail includes brass fittings, so ensure your drill bits match the anchor size.
Installation steps
- 1. Mark the bracket positions: Hold the rail against the wall at your desired height, using a level to ensure it's straight. Mark the screw holes for both brackets with a pencil. Common mistake: marking only one bracket and assuming the other aligns – always measure the exact distance between brackets.
- 2. Drill pilot holes: Drill pilot holes at your marks. For the Wilbur rail's solid brass fittings, use a drill bit slightly smaller than the wall anchor to avoid splitting the wood or damaging the fitting. Checkpoint: if you hit a stud, you may not need anchors; if drilling into tile, use a tile bit and slow speed to prevent cracking.
- 3. Insert wall anchors: Tap the appropriate wall anchors into the pilot holes. For heavy rails like the Wilbur, use anchors rated for at least 50 lbs to ensure a secure hold. Common mistake: using anchors that are too short – they must be fully seated in the wall, not protruding.
- 4. Attach the brackets: Screw the mounting brackets onto the wall using the provided screws. Tighten firmly, but avoid overtightening which could strip the threads or damage the bracket. Checkpoint: after attaching, give each bracket a gentle tug to confirm it's secure before hanging the rail.
- 5. Hang the towel rail: Place the double towel rail onto the brackets. For the Wilbur design, the rail should sit snugly on the brass fittings – no additional screws are usually needed. Common mistake: forcing the rail if it doesn't align – check that both brackets are level and at the same height.
Product used in this guide
-
Wilbur Double Towel Rail: Crafted from rich mango wood with a warming dark stain and solid brass fittings with an antiqued finish. The wood and brass construction means you need to drill into solid wall material for a secure fit, not just drywall without anchors.
Wilbur Double Towel Rail
