Quick answer
The Lascal BuggyBoard Universal Connector Kit lets you move your BuggyBoard between pushchairs without tools. Follow these steps to install it securely.
What the kit includes
The kit contains two BuggyBoard connectors, two cotter pins, friction pads, and a strap with hook to hold the board up when not in use. It is designed to work with any BuggyBoard model, so you can reuse your board on a second pushchair without buying a new one.
Why use the universal kit instead of a dedicated connector
Dedicated connectors are often pushchair-specific and require permanent installation. The universal kit gives you the flexibility to swap the board between strollers or store it upright when you don't need it. The trade-off is that you must check compatibility with your pushchair's frame shape; some oval or very thick frames may need extra padding (not included).
Step-by-step installation guide
- Attach the connectors to the pushchair frame: Slide each connector onto the rear frame tube where you want the BuggyBoard to sit. Ensure the friction pads face inward for a snug fit. Common mistake: positioning the connectors too far apart, which can make the board unstable. Check that the connectors sit level on both sides before tightening.
- Secure with cotter pins: Insert a cotter pin through the hole in each connector and bend the ends to lock it in place. This prevents the connector from sliding off during use. Common mistake: forgetting to bend the pins fully, which can cause them to fall out. Bend the pins at least 90 degrees to ensure they stay put.
- Attach the BuggyBoard to the connectors: Align the board's mounting bracket with the connectors and push until you hear a click. The board should lock into place securely. Common mistake: forcing the board onto misaligned connectors, which can damage the bracket. If it doesn't click easily, check that both connectors are aligned and level.
- Set up the strap and hook for storage: Wrap the strap around the pushchair frame above the board and hook it to the board's ring. When not in use, lift the board and hook it up so it doesn't drag on the ground. Common mistake: attaching the strap too loosely, allowing the board to swing. Tighten the strap so the board is held firmly against the frame when stored.
Product details
-
Lascal BuggyBoard® Universal Connector Kit - Black: Includes two BuggyBoard connectors, two cotter pins, friction pads, and a strap with hook to hold the board up when not in use. You get everything needed to transfer the board to a second pushchair without disassembling already fitted connectors.
Lascal BuggyBoard® Universal Connector Kit - Black
