Quick Answer
The Axial Yeti Sealed Bearing Kit includes 18 pieces of 5x11x4 and 6 pieces of 10x15x4 rubber-sealed bearings, giving you everything needed to replace every stock bearing in your Yeti. Follow the step-by-step guide below to swap them out and keep your rig running smoothly.
Why Sealed Bearings Matter for Your Yeti
The stock bearings in your Axial Yeti are open or shielded, which means they can let in dirt, sand, and water during crawls. Over time, this contamination leads to gritty feeling and premature wear. The rubber seals in the Axial Yeti Sealed Bearing Kit keep debris out and retain grease, extending bearing life and reducing maintenance frequency.
If you run your Yeti in dusty or wet conditions, upgrading to sealed bearings is a worthwhile investment. The kit's 5x11x4 bearings are commonly used in the wheel hubs and transmission, while the 10x15x4 bearings fit the differential and other larger bore locations. Replacing all of them at once ensures consistent performance and avoids mixing old and new parts.
Step-by-Step Bearing Replacement
- Gather Tools and Kit: Collect the Axial Yeti Sealed Bearing Kit, a small flathead screwdriver, a bearing press or socket set, and a clean workspace. Verify you have all 24 bearings (18 of 5x11x4 and 6 of 10x15x4) before starting. Check that the rubber seals are intact and free of damage before installation.
- Disassemble the Wheel Hubs: Remove the wheels and then the hub nuts using a wrench. Carefully pry out the old bearings using a screwdriver or bearing puller, working from the inside out to avoid scratching the hub. Common mistake: don't use excessive force, as you can damage the hub or axle threads. If bearings are stuck, apply gentle heat or penetrating oil.
- Press in New 5x11x4 Bearings: Place the new 5x11x4 bearings into the hub, ensuring they sit flush. Use a bearing press or a socket slightly smaller than the bearing outer diameter to press them in evenly. Do not hammer directly on the bearing. Make sure the bearing is fully seated and spins freely; if it binds, re-press it straight.
- Replace Transmission and Differential Bearings: Access the transmission and differential by removing the skid plate and gear covers. Remove the old bearings and press in the new ones, using the 10x15x4 size for differential and any larger bore locations. Pay attention to the orientation of any spacers. Check that all gears rotate smoothly after installation; a misaligned bearing can cause gear binding.
- Reassemble and Test: Reattach the wheels and all covers. Spin the drivetrain by hand to ensure everything rotates without resistance. Then take the Yeti for a short test run to confirm smooth operation. If you notice any grinding or wobble, disassemble and recheck the bearing seating and alignment.
Product Facts
-
Axial Yeti Sealed Bearing Kit: Includes 18pcs 5x11x4 Rubber Sealed Bearings and 6pcs 10x15x4 Rubber Sealed Bearings. This kit provides the exact bearing sizes needed to replace all the stock bearings in your Axial Yeti, so you don't have to source sizes individually.
Axial Yeti Sealed Bearing Kit
