Quick answer
To use the replacement sleeve for Remote Control Endure, remove the old sleeve, align the new one over the toy's shaft, and press it into place. Then check that it sits snugly before use.
Why the right fit matters
The replacement sleeve (BT-M38) is designed specifically for the Remote Control Endure. Using a sleeve from another toy can lead to a loose fit, which reduces sensation and may cause the sleeve to slip during use.
Before you start, make sure the toy is clean and dry. This helps the sleeve grip properly and keeps the material in good condition.
How to swap the sleeve
- Remove the old sleeve: Hold the base of the Remote Control Endure and gently pull the existing sleeve away from the shaft. If it resists, roll it down rather than yanking. Check that the old sleeve is fully off before moving on.
- Align the new sleeve: Line up the opening of the replacement sleeve with the tip of the toy. Make sure the sleeve is not twisted, as this can cause uneven texture. Look for any folds or bunched material before pressing it on.
- Press it into place: Slide the sleeve down the shaft, using your fingers to smooth it out. It should sit snugly without gaps or loose areas. Give it a gentle tug to confirm it stays in place.
- Clean and store: After use, remove the sleeve and wash it with mild soap and warm water. Let it air dry completely before storing it away from direct sunlight. Never store the sleeve while damp—this can damage the material.
Product fact
-
Replacement Sleeve For Remote Control Endure: This replacement sleeve (BT-M38) works with the Remote Control Endure. It ensures a secure, compatible fit so you can replace a worn or lost sleeve without buying a whole new toy.
Replacement Sleeve For Remote Control Endure
